CABLE AS - NEG 1550037 - Caterpillar

Install Tooling (C) to the threaded holes in piston (32). Install Tooling (A) and a suitable lifting device on Tooling (C), as shown. Remove piston (32) from the travel motor.
Illustration 15 g01283129
Remove O-ring seals (33) and (34) from the travel motor.
Illustration 16 g01283133
Remove separator plates (35) and friction plates (36) from the travel motor.
Illustration 17 g01283138
Illustration 18 g01283139Note: Barrel assembly (37), piston assemblies (39), and retainer (40) must remain intact during removal.
Position the travel motor sideways. Carefully remove barrel assembly (37) from shaft (38).
Illustration 19 g01283155
Place identification marks on piston assemblies (39), retainer (40), and barrel assembly (37). These components must be reinstalled in the original location.
Remove retainer (40) and piston assemblies (39) from barrel assembly (37).
Illustration 20 g01283175
Illustration 21 g01283193
Remove guide (41).
Remove springs (42).
Illustration 22 g01283187
Turn swashplate (43) counterclockwise in order to provide clearance for the removal of swashplate (43).
Remove swashplate (43) from the travel motor housing.
Illustration 23 g01283195
Remove piston (44) and pivots (45).
Illustration 24 g01283206
Use Tooling (D) in order to remove retaining ring (46) from shaft (38).
Illustration 25 g01283209
Use a soft hammer in order to drive shaft (38) and bearing (47) from the motor housing.
Illustration 26 g01283212
Use Tooling (E) in order to remove retaining ring (48) from bearing (47).
Illustration 27 g01283232
Use a suitable press in order to remove bearing (47) from shaft (38).
Illustration 28 g01283244
Remove retaining ring (49) and bearing race (50).
Illustration 29 g01283253
Use Tooling (F) in order to remove lip seal (51) from the travel motor housing.