CABLE AS- 1574829 - Caterpillar

Illustration 9 g01460652
Keep hands clear of fan while engine is running. May cause serious injury or death.
Fall Hazard (8)This safety message is positioned on the battery box on each side of the machine.
Illustration 10 g01393287
Do not use this surface as a step or platform. This surface may not support additional weight or may be slippery. Serious injury or death could occur from a fall.
Engine Coolant (9)This safety message is positioned on the underside of the radiator cap access cover on top of the engine compartment.
Illustration 11 g01371640
Pressurized system! Hot coolant can cause serious burns, injury or death. To open the cooling system filler cap, stop the engine and wait until the cooling system components are cool. Loosen the cooling system pressure cap slowly in order to relieve the pressure. Read and understand the Operation and Maintenance Manual before performing any cooling system maintenance.
Refer to Operation and Maintenance Manual, "Cooling System Coolant Level - Check" for more information.No Clearance (10)This safety message is positioned near the center pivot on both sides of the machine.
Illustration 12 g01371647
Connect the steering frame lock between the front and the rear frames before lifting, transporting, or servicing the machine in the articulation area. Disconnect the steering frame lock and secure the steering frame lock before resuming operation. Severe injury or death could occur.
Refer to Operation and Maintenance Manual, "Steering Frame Lock" for more information.Accumulator (11)This safety message is positioned on the brake accumulators. The brake accumulators are located at the rear of the cab.
Illustration 13 g01371642
Cold ambient temperatures could result in the loss of secondary braking capability due to inadequate hydraulic accumulator nitrogen pre-charge. The loss of the secondary braking system as well as the main hydraulic pressure will result in little or no braking capability and a potential for injury or death.It is recommended to perform a brake accumulator check anytime the machine has been idle for longer than two hours below −25 °C (−13 °F). Refer to Operation and Maintenance Manual before performing any check of the brake accumulator.
Hydraulic accumulator contains gas and oil under high pressure. Improper removal or repair procedures could cause severe injury. To remove or repair, instructions in the service manual must be followed. Special equipment is required for testing and charging.
Product Link (12) (If Equipped)This safety message is attached to the dash or to another area of the cab that is visible to the operator.
Illustration 14 g01370917
This machine is equipped with a Caterpillar Product Link communication device. When electric detonators are used, this communication device should be deactivated within 12 m (40 ft) of a blast site for satellite-based systems and within 3 m (10 ft) of a blast site for cellular based systems, or within the distance mandated under applicable legal requirements. Failure to do so could cause interference with blasting operations and result in serious injury or death.In cases where the type of Product Link module cannot be identified, Caterpillar recommends that the device be disabled no less than 12 m (40 ft) from the blast perimeter.