CABLE AS 1687927 - Caterpillar

Service the air cleaner only with the engine stopped. Engine damage could result.
Illustration 1 g00103765
Open the access door on the left side of the machine.
Illustration 2 g00103798
Loosen the three cover latches and remove the air cleaner cover.
Illustration 3 g00103799
Remove the primary filter element from the air cleaner housing.
Clean the air cleaner cover and the inside of the air cleaner housing.
Inspect the O-ring seal on the air cleaner cover. Replace the O-ring seal if the O-ring seal is worn or damaged.
Do not clean the filter elements by bumping or tapping them. Do not use filter elements with damaged pleats, gaskets or seals. Engine damage can result.Make sure the cleaned filter elements are completely dry before installing into the filter housing. Water remaining in the elements can cause false indications of contamination in Scheduled Oil Sampling test results.
Clean the primary filter. Inspect the primary filter. Primary filter elements can be cleaned with pressure air, pressure water or a detergent washing. When pressure water is used the maximum pressure should not exceed 280 kPa (40 psi).Refer to Operation and Maintenance, "General Hazard Information" before you use pressure air in order to clean the primary filter element.
Illustration 4 g00102884
Direct air or direct water along the pleats inside the primary filter element and outside the primary filter element.The primary filter element can be washed in warm water and nonsudsing household detergent. Rinse inside the pleats and outside the pleats. Allow the primary filter element to air dry fully.
Inspect the primary filter element after cleaning. Do not use a primary filter element with damaged pleats, damaged gaskets or damaged seals.
Encase the clean primary filter element and store the clean primary filter element in a clean, dry place.
Install the clean primary filter .
Install the air cleaner cover and close the latches securely.
Illustration 5 g00103800
Note: Install the air cleaner cover properly. The arrow must point upward.
Change the filter if any of the following conditions occurs:
Restricted Air Filter indicator on the monitor panel still comes on.
Exhaust smoke is still black after the installation of a primary filter.Note: The primary filter can be cleaned up to six times. Replace the primary filter if the primary filter has been in service for one year.