CABLE AS - 1869037 - Caterpillar

Installation Procedure
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 1 g01386192
Typical Example
Illustration 2 g01386164
Install a new gasket. Attach a suitable lifting device to cylinder head (5). The weight of cylinder head (5) is approximately 80 kg (177 lb). Use the suitable lifting device in order to position cylinder head (5) on the engine block.
Tighten bolts (6) in the sequence that is shown in Illustration 2 to a torque of 137 5 N m (101 4 lb ft).
Illustration 3 g01375622
Install a new gasket and connect tube assembly (4). Install bolts (3) .
Connect tube assembly (2) .
Illustration 4 g01375619
Connect hose (1) .End By:
If necessary, install the water temperature regulator. Refer to Disassembly and Assembly, "Water Temperature Regulator - Remove and Install".
If necessary, install the inlet manifold. Refer to Disassembly and Assembly, "Inlet Manifold - Remove and Install".
If necessary, install the exhaust manifold. Refer to Disassembly and Assembly, "Exhaust Manifold - Remove and Install".
Install the electronic unit injectors. Refer to Disassembly and Assembly, "Electronic Unit Injector - Install".
Install the rocker shaft and pushrods. Refer to Disassembly and Assembly, "Rocker Shaft and Pushrods - Install".
Install the valve mechanism cover base. Refer to Disassembly and Assembly, "Valve Mechanism Cover Base - Remove and Install".