CABLE-SERIAL 1960055 - Caterpillar

Illustration 14 g03372370
Install bolts (30) and the spacers.
Illustration 15 g03372366
Install bolts (29) and the spacers.
Illustration 16 g03372365
Install exhaust tubes (28).
Illustration 17 g03372362
Connect V-band clamp (27). Install clamp (26). Install bolts (25). Tighten V-band clamp (27) to a torque of 8.5 2 N m (75 18 lb in). Repeat this step for the opposite side.
Illustration 18 g03372359
Install bracket (24). Install bolts (23).
Illustration 19 g03372329
Install bolts (22). Repeat this step for the opposite side.
Illustration 20 g03372327
Install tube assembly (21). Install clips (20). Connect clamp (19). Repeat this step for the opposite side.
Illustration 21 g03372347
Install tube assemblies (18).
Illustration 22 g03372324
Connect V-band clamps (17). Tighten V-band clamps (17) to a torque of 8.5 2 N m (75 18 lb in).
Illustration 23 g03372321
Connect clips (16), hose assembly (15), clips (14), tube assembly (13).
Illustration 24 g03372320
Connect clips (12), tube assembly (11), and hose assembly (10).
Illustration 25 g03372318
Illustration 26 g03372319
Connect clips (9), clips (8), and hose assemblies (7). Repeat this step for the opposite side.
Illustration 27 g03372120
Install hoses (6) and connect clamps (5). Tighten clamps (5) to a torque of 10 2 N m (89 18 lb in).Repeat this step for the remaining hoses (6) and clamps (5).Note: Orientate the T-bolts of clamps (5) 180° 90° apart. Do not align the T-bolts of clamps (5) side by side.
Illustration 28 g03372796
Connect clamps (4) and clamps (1). Install new bellows (3) and new bellows (2). Note: The bellows are not reusable. Replace with new bellows.
Tighten clamps (4) and clamps (1) that are indicated with an (X) to a torque of 17 3 N m (151 27 lb in).
Tighten clamps (4) and clamps (1) that are indicated with an (Y) to a torque of 7.5 1 N m (66 9 lb in).End By:
Install the rear exhaust.