CABLE AS 1C4013 - Caterpillar

Changing Machine Control Pattern By Four-Way Valve (If Equipped)
Whenever a change is made to the machine control pattern, also exchange the pattern card in the cab to match the new pattern.Check the machine control pattern for conformance to the pattern on the card in the cab. If the pattern does not match, change the card to match the machine control pattern before you operate the machine. Failure to do so could result in personal injury.
If the machine is equipped with a four-way valve, the machine control pattern can easily be changed. The machine control pattern can be changed to the SAE pattern, MHI pattern, KOB pattern, or the former SCM pattern by changing the four-way valve position. To change the four-way valve position, use the following procedure.
Illustration 1 g02042113The four-way valve (if equipped) is located underneath the cab floor.
Illustration 2 g02042133
(a) Lever
(b) Bolt
(1) MHI machine control pattern
(2) CJL machine control pattern
(3) KOB machine control pattern
(4) SAE machine control pattern
Open the access cover in the floor of the cab.
Loosen bolt (b) and move lever (a) to the desired position. The lever can be moved to position (1), (2), (3), or (4).Position (1) will change the machine control pattern to the MHI pattern. Position (2) will change the machine control pattern to the CJL pattern. Position (3) will change the machine control pattern to the KOB pattern. Position (4) will change the machine control pattern to the SAE pattern.
After the pattern is set, tighten the bolt to secure the lever.
Illustration 3 g00102959
(A) SAE machine control pattern
(B) MHI machine control pattern
(C) KOB machine control pattern
(D) Former SCM machine control patternThe patterns on the left side of the illustration show the possible configurations for the left control lever. The patterns on the right side of the illustration show the possible configurations for the right control lever.
Stick Out (1) - Move the control lever to this position to move the stick outward.
Swing Right (2) - Move the control lever to this position to swing the upper structure to the right.
Stick In (3) - Move the control lever to this position to move the stick inward.
Swing Left (4) - Move the control lever to this position to swing the upper structure to the left.
Boom Lower (5) - Move the control lever to this position to lower the boom.
Bucket Dump (6) - Move the control lever to this position to dump the bucket.
Boom Raise (7) - Move the control lever to this position to raise the boom.
Bucket Close (8) - Move the control lever to this position to close the bucket.HOLD (9) - When the control lever is released from any position, the control lever will return to the HOLD position. Movement of the upper structure will stop.Two functions may be performed at the same time by moving a control lever diagonally.If the machine is equipped with a hydraulic hammer, the function of position (6) and of position (8) is different.Hydraulic Hammer Raise (6) - Move the control lever to this position to raise the hydraulic hammer.Hydraulic Hammer