CABLE GP-GOVERNOR CONTROL 3095899 - Caterpillar

Installation position (c)
Pump/motor inside the tank (below the minimum oil level). With units in which the suction and drain chambers are connected internally, complete bleeding of the unit must be carried out, as it is not possible to drain fill the housing. In units with separate suction and drain chambers, the unit must be filled before installation. The connections may then only be opened when they are below oil level in order to avoid the entry of air and loss of fluid.Suction
Minimum immersion level (E) For installation positions (a) and (b), the prescribed minimum immersion level (E) must be maintained. This dimension applies to suction, drain and bleed lines, see figure 4. Minimum distances (TU) and (SU). Dimension (TU) for the highest drain port (T), and dimension (SU) for suction port (S) must be maintained. The bleed port (U) is not used in this case. In mobile installation, the tank layout must be carefully designed in order to prevent air being sucked in, see figure 5. Note The optimum filling positions and the permissible installation positions and installation orientations for our pumps and motors are shown on the following pages.These pages are subdivided into three columns:Installation positions (a), (b) and (c)and also into five horizontal blocks:1.) installation orientation (1)2.) installation orientation (1) (turned 180° about its longer axis)3.) installation orientation (2)4.) installation orientation (3)5.) installation orientation (4)This sequence applies to each of the relevant pages. If a column or row is blank, this installation position or installation orientation is not permitted by Hydromatik, or requires further steps to be taken to ensure correct installation. Please enquire for further information. Spare