CABLE AS-PARKING BRAKE CONTROL 3153622 - Caterpillar

Table 13
Low Speed Shaft Alignment (mils)    
Engine    Vertical    Horizontal    Vertical Angle (mils/10 inches Diameter)    Horizontal Angle (mils/10 inches Diameter)    
G3408     3 4     0 4     0 4     0 4    
G3412     3 4     0 4     0 4     0 4    
G3508     -6 4     0 4     0 5     0 5    
G3512     -6 4     0 4     0 5     0 5    
G3516     -7 4     2 4     0 5     0 5    Prestart Information
Provide the driveline with the 480 volts power supply and the 24 volt power supply. Ensure that all the control panels are activated.Check the oil pump of the transmission gear for the correct rotation. Actuate C2 in the electrical panel (AC) while you are watching the oil pressure gauge. If the pump does not produce pressure, change the rotation of the pump.With the engine control switch in the AUTO position, turn on the jacket water heater. Check for warming at the heater's outlet. If the heater's outlet does not warm up, check the setting of the thermostat. Reset the thermostat to 50°C (120°F).Connect a jumper wire from Terminal 301 in the engine's control panel to the 24 volt power supply. Adjust the air pressure to the clutch to 792.8 kPa (115 psi) for the following models:
G3408
G3412
G3508
G3512Adjust the air pressure to the clutch to 862 kPa (125 psi) for the G3516.Engage and disengage the clutch. Adjust the air pallet needle valve until the air pressure gauge indicates 792.8 kPa (115 psi) (two seconds after the actuation). The pressures that are mentioned above are applicable to the following models:
G3408
G3412
G3508
G3512Adjust the air pallet needle valve until the air pressure gauge indicates 862 kPa (125 psi) for the G3516 (two seconds after the actuation). Lock down the needle valve by using the setscrew in the handle. Remove the jumper wire.Check the throttle linkage for the correct adjustment. Ensure that the throttle linkage moves easily.Purge the fuel supply line to the regulator until gas is available.Install a water manometer in order to measure the air/fuel differential pressure on each carburetor.Install a pressure gauge on the fuel supply line.Install a pressure gauge on the water line which flows to the driveline. Also install a pressure gauge on the water line which flows from the driveline.Install the exhaust analyzer.Check the program's settings on the status control module.The Initial Settings For The 2301A
Since the governor has been set at the factory, only minor adjustments are necessary. The following settings are used as initial governor speed settings only.
Table 14
The Initial Settings For The 2301A    
Parameter    G3400    G3500    
Gain     6     2    
Reset     8     9.5    
Compensation     6     3    
Start Fuel Limit Position     3     3    
Range     1800