CABLE AS 3886892 - Caterpillar

Illustration 7 g01027385
Install pin (18) toward the center of frame (19) enough so pin (20) can be installed. Pull pin (18) into frame (19) so that pin (20) is seated in the groove in the frame.
Illustration 8 g01027383
Install the washer and nut (17). Tighten nut (17) to a torque of 500 60 N m (370 45 lb ft).
Illustration 9 g01027373
Install plate (16) and install bolts (15). Tighten bolts (15) to 250 40 N m (185 30 lb ft).
Illustration 10 g01027360
Install plate (14) and the O-ring seal (not shown). Install bolts (13) and the washers.
Illustration 11 g01147082
Attach a suitable lifting device and Tooling (B), as shown. Install the gear and bearing group with the frame. The weight of the gear and bearing group with the frame is approximately 1725 kg (3800 lb).
Illustration 12 g01027259
Use a suitable lifting device and a suitable pry bar in order to tilt the cab leveling tilt group, as shown.
Install the tapered pins into the sides of the frame. Refer to the information at the end of this procedure for installation instructions for the tapered pins.
Illustration 13 g01147084
Install pins (10) for both cylinders. Pin (10) should be centered.
Illustration 14 g01147097
Install plates (9) to each side of pin (10) .
Illustration 15 g01147104
Illustration 16 g01028366
Install bolt (8) and plate (9) to each side of pin (12). Torque bolts (10) to a torque of 425 50 N m (315 36 lb ft). Check the gap between plate (9) and the frame. The Gap (A) should exist on one or both sides.
Illustration 17 g01147121
Install pin (6). Pin (6) should be installed through the block, through the rod end of the tilt cylinder, and then through the block. The smaller diameter of pin (6) should be installed first. The smaller diameter of pin (6) should reside in the block. Tighten bolts (5) in small increments. The gap between the blocks and the frame should be equal. Tighten bolts (5) in small increments until the final torque is 800 100 N m (590 75 lb ft).
Illustration 18 g01027140
Attach cable assemblies (3) and (4). Install washers and nuts (1) and (2). Tighten nuts (1) and (2) to a torque of 500 60 N m (370 45 lb ft).Installation of the Tapered Pins
Use the following procedure for installing the tapered pins.
Illustration 19 g01028204
Install the plate and seal (1). Plate (1) should be installed to a depth of 98 mm (3.8 inch) (A), as shown.
Install plate (2) onto the end of pin (4). Use bolt (3) in order to hold plate (2) onto pin (4). Install pin (4) and plate (2) until the edge of pin (4) is even with the edge of frame (6). Remove bolt (3) .
Install plate (5) onto pin (4). Press plate (5) into the frame until the shoulder of plate (5) rests on the edge of frame (6).
Install the bolt (3) and plate (7). Tighten the bolt to 650 80 N m (480 60 lb ft).End By: Install the upper frame. Refer to Disassembly and Assembly, "Upper Frame - Install".