CABLE ASSEM. 3V1767 - Caterpillar

Illustration 1 g01417382
Front view
Illustration 2 g01434393
Right side view
Note: During assembly, the bottom of spacer plates, top of cylinder block and both sides of plate gasket must be free of fuel, oil, water, gasket adhesives, assembly compounds and any other contaminants. (A) Thickness of the spacer plate ... 12.313 mm (0.4848 inch) (B) Thickness of the plate gasket between the cylinder block and spacer plate ... 0.194 to 0.218 mm (0.0076 to 0.0086 inch) (C) Extension of the dowel from the top face of the cylinder block ... 21.0 0.5 mm (0.83 0.02 inch) (1) Torque for four plugs ... 100 15 N m (75 11 lb ft) (2) Lubricate the bore of the O-ring seals lightly with the lubricant that is being sealed. (D) Height of the cylinder liner For the correct method of determining the height of the cylinder liner, refer to Testing And Adjusting, "Cylinder Liner Projection". (E) Bore in the block for the camshaft bearings ... 98.000 0.020 mm (3.8583 0.0008 inch) (F) The oil holes in the camshaft bearings must be positioned from horizontal at the following angle: ... 20 5 degreesNote: All centerlines through the oil holes in the camshaft bearings (F) and the camshaft bearing joints (3) must be in the position that is shown for each side of the cylinder block. (G) New dimension from centerline of crankshaft bearing bore to the top of the block ... 586 mm (23.1 inch) (H) New dimension from centerline of crankshaft bearing bore to bottom of block (pan rails) ... 230 mm (9.1 inch) (J) Bore in the block for the main bearings Standard, original new size ... 169.742 0.020 mm (6.6827 0.0008 inch) 0.63 mm (0.025 inch) larger than original size ... 170.372 0.020 mm (6.7075 0.0008 inch) (K) Dimension for crankshaft main bearing cap Width of crankshaft main bearing cap ... 340.030 0.015 mm (13.3870 0.0006 inch)Width of cylinder block for crankshaft main bearing cap ... 339.985 0.015 mm (13.3852 0.0006 inch)Tight press fit between the sides of the crankshaft main bearing cap and the cylinder block ... 0.075 mm (0.0030 inch)Loose press fit between the sides of the crankshaft main bearing cap and the cylinder block ... 0.015 mm (0.0006 inch) (4) Main bearing cap Use the following procedure to tighten the crankshaft main bearing cap bolts:
Install main bearing caps with the part number and "FRONT" toward the front of the block. Each cap has a number. Each cap must be installed in the same position as the correct number on the side of the cylinder block pan rail.
Before assembly, apply clean engine oil on the threads of the bolts.
Tighten bolt (5) through bolt (8) in the numerical sequence that is shown in Illustration 1 to a torque of 190 14 N m (140 10 lb ft).
Tighten bolt (5) through bolt (8) again in the numerical sequence to a rotation of 180 5 degrees.