CABLE AS 5315145 - Caterpillar

Table 1
Service Tools
Part Number Part
146-4080 Digital Multimeter
7X-1710 Multimeter Probe Group
8T-8726 "3 Pin Cable Assembly"
6V-3000 Connector Repair Kit (Sure Seal)
9U-7246 Connector Repair Kit (Deutsch DT Type)
4C-3406 Connector Repair Kit (Deutsch)
8T-3224 Needle Tip Group
4C-8195 Control Service Tool (Switch Box)
157-4829 Cable Adapter
478-0235(1) Caterpillar Communication Adapter 3
457-6114(1) Com Adapter 3, Data Link Cable Assembly (Ethernet FLASH)
370-4617(1) Com Adapter 3, PC USB Cable
Caterpillar Electronic Technician (Cat ET)
Plus+1 Service Tool for Caterpillar software
480-5264(2) Communication Cable, CAN (DB9) to USB adapter (CG-150-2)
300-7925(2) Communication Cable As., DB9 PC Serial Port to 3-pin receptacle Deutsch connector adapter
484-9472(2) Adapter Cable As., 9-pin and 14-pin Deutsch connector plug (Service Port) to 3-pin Deutsch connector plug adapter
(1) Part of 466-6258 Adapter Gp
(2) Required for ECM “Recovery” ProcedureNote: The ECM “Recovery” cables can be used with any instructions contained in this manual. The requirement of an ECM recovery procedure while troubleshooting or servicing the machine is highly unlikely.
Illustration 1 g03846497
Components of the Communication Adapter 3 Gp (466-6258) are listed:
(1) Current version of Cat ET software for use with a Windows-based personal computer
(2) 478-0235 Control Gp-Electronic (Com Adapter 3)
(3) 457-6114 Cable As. (CA3 - Ethernet FLASH Cable)
(4) 370-4617 Cable As. (CA3 PC USB Cable)
Illustration 2 g03845540
Supports both 9-Pin and 14-Pin SAE J1939 Comm Adapter connections
(3) CA3 Ethernet FLASH Cable (457-6114)Note: Plus+1 Service Tool for Caterpillar software will be required in addition to Cat ET software.Reference: See Special Instruction, REHS7696, "Software Installation Instructions of the Plus+1 Service Tool for Caterpillar" for details.For instructions on servicing Sure Seal connectors, see Special Instruction, SMHS7531. For instructions on servicing Deutsch DT connectors, see Special Instruction, SEHS9516.Use the digital multimeter for making continuity checks or for measuring voltage. The 7X-1710 Multimeter Probe is used to measure the voltage without disconnecting the connector. The probe cables are pushed into the back of the connector along the wire. The 8T-8726 Adapter Cable has a breakout of 3 pins. The adapter cable is used for measurements in the sensor circuits.Note: Except for harness tests, the following is not recommended for Caterpillar electrical circuits:
Continuity Testers (such as the 8T-0500 Continuity Tester)
Voltage Testers (such as the 5P-7277 Voltage Tester)