CABLE 5E8827 - Caterpillar

Illustration 5 g03739886
Install a bracket assembly (23), two screws (15) and two hard washers (5) on the bottom right and on the bottom left cab front frame.
Illustration 6 g03739890
Install a latch assembly (10) by using bolt (3) and washer (11) with Loctite 242.
Install pedal assembly (27) by using a boss (16), a cushion (30), bolt (3), and washer (11).
Illustration 7 g03740035
Install a grommet (18) and knob (1).Note: Tighten knob (1) by hand.
Install a bumper (14) by using two nuts (13) and two hard washers (7).
Illustration 8 g03740074
Install a latch assembly (10) by using bolt (3) and washer (12) with Loctite 242.
Install pedal assembly (28) by using a boss (16), a cushion (30), bolt (3), and washer (11).
Illustration 9 g03740146
Install a grommet (18) and knob (1).Note: Tighten knob (1) by hand.
Install a bumper (14) by using two nuts (13) and two hard washers (7).Note: The bumper position will be adjusted when installing the guard assembly.
Illustration 10 g03740184
Before installing guard assembly (22) to the cab, install striker assembly (29) and gas spring assembly (26) to the guard assembly.
Install a striker assembly (29) to the bottom right, and to the bottom left, of guard assembly (22) by using three bolts (9) and three hard washers (8).Note: The striker position will be adjusted when installing the guard assembly.
Illustration 11 g03740208
Install a gas spring assembly (26) on the bottom right, and on the bottom left, of guard assembly (22) by using a retaining ring (2).
Illustration 12 g03740245
Install guard assembly with striker assembly and gas spring assembly on the cab by using two bolts (17), two hard washers (31), and two locknuts (4).Note: The weight of the guard assembly is approximately 84.5 kg (186.3 lb).
Illustration 13 g03740443
Loosen three bolts (9). Adjust striker assembly (29) position for smooth operation of the latch.
Tighten three bolts (9) to secure striker assembly (29) at the appropriate position.
Illustration 14 g03740460
Loosen nuts (13). Adjust bumper (14) position so that the bumper contacts the guard assembly when latched in order to prevent rattles.
Tighten nuts (13) to secure bumper (14) at the appropriate position.
Illustration 15 g03740485
Apply film (19) and film (32) on top of the front guard.Film Installation
Avoid prolonged skin contact with isopropyl alcohol. Avoid breathing the vapors in enclosed areas without adequate ventilation and do not smoke.Isopropyl alcohol is flammable. Do not use near open flame, welding operations, or around heated surfaces exceeding 482°C (900°F).
Surface preparation is important in the installation of films. The surface must be clean and dry in order for the films to adhere to the machine. Be sure that oil, grease, and dirt have been removed before you install the new films. The installation instructions that follow are recommended:
A 50:50 mixture of isopropyl alcohol and water is generally an adequate cleaning agent for cleaning the mounting surface.
Apply solvent to the contact area. Wipe the surface with a lint free cloth until the surface is dry.
Carefully remove the liner from the back of the film. Avoid touching the adhesive.
Apply the film to the surface.Note: The film cannot be repositioned once the film is applied. If the film is installed