CABLE A TACH 5P7362 - Caterpillar

1. Remove shift knob (1) from the shift knob lever. Remove four bolts (2) from cover (3). Remove cover (3) from the control panel. Remove six bolts (4) from front cover (5). Remove cover (5) from the control panel. 2. Remove two knobs (6) from side panel (9). Remove two bolts (7) and cap (8) from side panel (9). Remove side panel (9) from the control panel. 3. Remove four bolts (10) that hold cover (12) in the control panel. Move shifter lever (11) out of the park position. Remove shift control assembly (18) from the control panel.
Do not disconnect any air line to the machine until the air pressure in the air tank is to zero. Release the air pressure in the air tank by opening the bleed valves. The bleed valves are on the air tank underneath the rear bumper. Close the bleed valves.
4. Remove bolt (14) and disconnect electrical socket (16) from shift control box (18). Put identification marks on the two air hoses for installation purposes. Disconnect the fittings on air hoses (15) and (17) from parking control air valve assembly (13). Remove shift control box (18) from the control panel. 5. Note the positions of elbows (19) and (22) for installation purposes. Remove two elbows (22) and elbow (19) from parking brake control air valve assembly (20). Loosen jam nut (21) and remove valve assembly (20) from shift control box (18).Install Parking Brake Control Air Valve Assembly
1. Clean all components of the parking brake control air valve assembly and the mating components before installing them. Check the condition of all O-ring seals used in the hose assemblies that were disconnected. If any of the seals are damaged, use new parts for replacement. 2. Install elbows (19) and (22) on parking brake control air valve assembly (20), and facing in their original direction. Install parking brake control air valve assembly (20) on shift control box (18) and facing its original direction. With the shift control lever in the "Neutral" position adjust valve assembly (20) in order to provide 0.5 to 1.0 mm (.02 to .04 in) clearance with the actuator. 3. Install shift control box (18) in the control panel housing. Connect electrical socket (16) to shift control box (18). Install bolt (14) in order to secure electrical socket (16) to shift control box (18).4. Connect hose assemblies (15) and (17) to parking brake control air valve assembly (13).5. Position shift control assembly (18) to the control panel. Install four bolts (10) that hold shift control assembly (18) in the control panel. 6. Position side panel (9) to the control assembly. Install two knobs (6) to side panel (9). Install two bolts (7) and cap (8) to side panel (9). 7. Position front cover (5) to the control assembly. Install six bolts (4) to front cover (5).8. Position cover (3) to the control assembly. Install shift knob (1) to the shift knob lever. Install four bolts (2) to cover (3).End By:a. install seat assemblyDisassemble