CABLE AS 7T1971 - Caterpillar

Removal Procedure
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Dispose of all fluids according to local regulations and mandates.
Note the position and orientation of any blanking plates that are removed from the engine oil system for installation purposes.
Illustration 1 g01340605
Typical example
If necessary, remove the assembly of dipstick tube. Loosen nut (1) and remove tube assembly (2). remove seal (3) from the tube assembly.Note: Identify the position and orientation of the tube assembly.
Illustration 2 g01340606
Typical example
Place a suitable container below engine oil pan (7). Remove drain plug (5) and drain the engine lubricating oil. Refer to Operation and Maintenance Manual, "Engine Oil and Filter - Change" for the correct procedure.
Remove O-ring seal (6) from drain plug (5).
Disconnect breather hose from the clip that secures the hose to the engine oil pan. Position the breather hose away from the engine oil pan.
Support the assembly of the engine oil pan. Loosen the long isolating screws (8) and the two short isolating screws (9). Mark the position of the clip that secures breather hose . Remove the clip.Note: The isolating screws are held captive by joint (4).
Remove the assembly of the engine oil pan from the engine.
If necessary, remove the plate for the engine oil pan. Refer to Disassembly and Assembly, "Engine Oil Pan Plate - Remove and Install" for the correct procedure.