CABLE AS 7T6157 - Caterpillar

VA Boom Retract - Push down on the rear of the pedal in order to retract the VA boom. Super Long Demolition Configuration (If Equipped)
Illustration 9 g00455065
(A) Boom (Foot and Nose) (B) Fore boom (C) Stick (D) Linkage
Illustration 10 g00291808
The machine control pattern can be varied by changing the hydraulic hose connections. See your Caterpillar dealer for the procedure.
Illustration 11 g00101278
The machine control pattern is initially set at the factory to the SAE system, as shown. The pattern on the left pertains to the left control lever and the pattern on the right pertains to the right control lever.Stick Out (1) - Move the control lever to this position in order to move the stick outward.Swing Right (2) - Move the control lever to this position in order to swing the upper structure to the right.Stick In (3) - Move the control lever to this position in order to move the stick inward.Swing Left (4) - Move the control lever to this position in order to swing the upper structure to the left.Boom Lower (5) - Move the control lever to this position in order to lower the boom.Implement Open (6) - Move the control lever to this position in order to dump the bucket.Boom Raise (7) - Move the control lever to this position in order to raise the boom.Implement Close (8) - Move the control lever to this position in order to close the bucket.Hold (9) - When you release the control levers from any position, the control levers will return to the HOLD position. Movement of the upper structure will stop.Two functions may be performed at the same time by moving a control lever diagonally.The functions of positions (6) and (8) could be different if the machine has a different configuration.Note: Do not operate the implement by an additional pedal.
Illustration 12 g00291472
The pedal is located to the left of the travel pedals.
Fore Boom Extend - Push down on the front of the pedal in order to extend the fore boom.
Fore Boom Retract - Push down on the rear of the pedal in order to retract the fore boom. This configuration is equipped with the hydraulic attachment combined circuit and the rotate circuit. For more information, refer to Operation and Maintenance Manual, "Implement Flow Control" or Operation and Maintenance Manual, "Implement Flow Mode Control" .Note: In this configuration, the hydraulic attachment combined circuit cannot be operated by the pedal.Retrofit Configuration (If Equipped)
Left Implement Control Lever
Illustration 13 g00330763
Grapple Rotate Clockwise (10) - Press the left side of the top rocker switch in order to rotate the grapple clockwise.
Horn (11) - Press the lower switch on the top of the left control lever in order to activate the horn.
Grapple Rotate Counterclockwise (12) - Press the right side of the top rocker switch in order to rotate the grapple counterclockwise. Right Implement Control Lever
Illustration 14 g00455126
AEC Switch (13) - Press the lower switch on the top of the right control lever in order to activate low engine speed. Press the switch