CABLE AS 9G0713 - Caterpillar

Removal Procedure
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat products.Dispose of all fluids according to local regulations and mandates.
Do not disconnect the air lines until the air pressure in the system is at zero. If hose is disconnected under pressure it can cause personal injury.
Loosen the purge valves, and release the air pressure in the air tank.
Drain the coolant from the cooling system into a suitable container for storage or disposal. Refer to Operation and Maintenance Manual, "Cooling System Coolant - Change".
Illustration 1 g01456318
Disconnect hose assemblies (1) and (7) from air compressor (4).
Disconnect tube assemblies (2) and (3) from air compressor (4).
Remove bolts (6) and the washers.
Remove bolts (5) and the washers. Remove air compressor (4).
Remove the O-ring seal from air compressor (4). Installation Procedure
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 2 g01456318
Install a new O-ring seal on air compressor (4).
Position air compressor (4) on the engine.
Install the washers and bolts (5).
Install the washers and bolts (6).
Connect tube assemblies (3) and (2) on air compressor (4). Tighten the elbow on tube assembly (3) to a torque of 50 5 N m (37 4 lb ft).
Connect hose assemblies (7) and (1) to air compressor (4). Tighten the elbow on hose assembly (1) to a torque of 50 5 N m (37 4 lb ft).
Fill the cooling system. Refer to Operation and Maintenance Manual, "Cooling System Coolant - Change".