CAGE 1177252 - Caterpillar

1. Open the access cover on the right side of the machine. 2. Maintain the oil level between the ADD and FULL marks on the dipstick (1).3. Remove the oil fill plug (2) and add oil if necessary.4. Clean and install the fill plug.5. Close the access cover.Transmission Oil
Check the TDTO Oil Level
The transmission oil dipstick is located on the left side of the machine. 1. Maintain the oil between the ADD and FULL marks on the dipstick (1) at LOW IDLE.2. Remove the oil fill cap (2) and add oil if necessary.3. Clean and install the fill cap.Hydraulic Oil
Check the HYDO Oil Level
The hydraulic oil tank is located on the left side of the machine. 1. Maintain the oil level to the FULL mark on the sight gauge (1).2. Remove the oil fill cap (2) and add oil, if necessary, through the fill tube.3. Clean and install the fill cap.All attachments to be level and on the ground during filling.Cooling System
Look at the Coolant Level
The radiator cap is located in the hood of the machine at the left rear. 1. Open the access cover in the hood. 2. Remove the radiator cap slowly to relieve pressure. 3. Maintain the coolant level to within 1 cm (1/2 in) of the bottom of the fill pipe. If it is necessary to add coolant daily, check for leaks.4. Inspect the cap seal. Replace the cap if it is damaged.5. Install the cap. Close the access cover.Fuel Tank
Drain the Water and Sediment
Drain valve is located under the fuel tank. 1. Open the drain valve and allow the water and sediment to drain.2. Close the drain valve.Air Reservoirs
Drain Moisture and Sediment
The drain valve is located under the air reservoir in front of the fuel tank. Open the drain valve. Allow all condensation to drain. Close the drain valve. If the machine is equipped with an air dryer, this maintenance can be done every 50 service hours or once a week.Walk-Around Inspection
Inspect Machine
1. Inspect the engine precleaner bowl for dirt build-up. Remove dirt from bowl when any dirt has accumulated close to the full line on bowl. 2. Inspect the attachments and linkage for damage or excessive wear. Repair if damaged. 3. Inspect the lights for broken bulbs and lenses. Replace if broken. 4. Inspect and remove any trash build-up in the engine compartment.5. Inspect the cooling system for leaks, faulty hoses and trash build-up. Correct any leaks and remove any trash from radiator. 6. Inspect the hydraulic system for leaks. Inspect the tank, hoses, tubes, plugs, joints and fittings. Correct any leaks. 7. Inspect differentials (front and rear) under machine for leaks. 8. Inspect final drives (front and rear) for leaks. 9. Inspect transmission for leaks. 10. Inspect tires (front and rear) for damage and proper inflation. Replace any missing valve caps. 11. Inspect the wheel brakes for oil leaks. 12. Be sure the covers and guards are firmly in place. Inspect for damage. 13. Inspect the steps, walkways and handholds