CAGE-ROLLER 1415950 - Caterpillar

Improper operation of an access platform could result in injury or death.Operators must carry out their duties properly and follow all instructions and guidelines given for the machine and access platform.
Install the access platform (work tool) to the quick coupler. Refer to the following information for the installation and the operation of the access platform (work tool).
Operation and Maintenance Manual, SEBU7371, "Quick Coupler (Hydraulic)" or
Operation and Maintenance Manual, SEBU7371, "Quick Coupler (Manual)"
Operation and Maintenance Manual, SEBU7371, "Access Platform".
Operation and Maintenance Manual, SEBU7371, "Access Platform Control".
Operation and Maintenance Manual, SEBU7371, "Before Operating Machine".Travel
Ensure that the parking brake is engaged and that the transmission control is in the NEUTRAL position. Ensure that the key switch for the lockout system is turned as far as possible in a counterclockwise direction.
Ensure that the access platform (work tool) is in the TRAVEL position. When the machine is in the TRAVEL position, the boom is fully retracted and the floor of the access platform (work tool) is within 450 mm (18 inch) of the ground. Check the LED on both of the position sensors and ensure that the LED is on. Disengage the parking brake and move the transmission control to the FORWARD position. Check that the machine travels.
Leave the transmission control in the FORWARD position. Raise the access platform (work tool) from the TRAVEL position until the LED on the rear position sensor is off. Check that the machine does not travel.
Leave the transmission control in the FORWARD position and lower the boom in order to return the access platform (work tool) to the TRAVEL position. Check that the machine does not travel.
Move the transmission control to the NEUTRAL position. Engage the parking brake and then disengage the parking brake. Move the transmission control to the FORWARD position. Check that the machine travels.
Leave the transmission control in the FORWARD position and extend the boom from the TRAVEL position until the LED on the front position sensor is off. Check that the machine does not travel.
Leave the transmission control in the FORWARD position and retract the boom in order to return the access platform (work tool) to the TRAVEL position. Check that the machine does not travel.
Repeat Step 5.
Shut off the engine.Lockout of Access Platform Control Switches
Ensure that the key switch for the lockout system is turned as far as possible in a counterclockwise direction.
Ensure that the push button