CAGE-BEARING 2244819 - Caterpillar

Procedure to Tilt the Cab
Start By:
Release the hydraulic system pressure. Refer to Disassembly and Assembly, "Hydraulic System Pressure - Release".
Do not go beneath cab unless cab is empty and support lever is engaged.Failure to follow the instructions or heed the warnings could result in injury or death.
Note: Empty the water tank (if equipped) before you tilt the cab.
Illustration 1 g01049069
Loosen bolt (1) .Note: Bolt (1) will be retained in the cab.
Illustration 2 g01049070
Remove nut (2) and large washer (3) from the inside of the cab.
Repeat Steps 1 and 2 on the opposite side of the cab.
Illustration 3 g01049074
Raise cab (4) .
Illustration 4 g00563598
Engage cab support lever (5) .Lower Procedure
Illustration 5 g01049074
Illustration 6 g00563674
Tilt the cab upward.
Disengage cab support lever (5) .
Lower cab (4) .
Illustration 7 g01049069
Align bolt (1) .
Illustration 8 g01049070
Note: Ensure that the large washer is between the nut and the rubber mounting.
Install large washer (3) and nut (2) from the inside of the cab. Tighten the nuts to a torque of 125 10 N m (92 7 lb ft).
Repeat Steps 4 and 5 on the opposite side of the cab.