CAGE 2664311 - Caterpillar

Recoil compartment oil level must be checked with the tracks installed and adjusted to the correct sag before checking oil level on dipstick (5).Oil Fill Procedure For Pivot Shaft
1. Remove plugs (4) from both roller frames and make sure the hose from the pivot shaft oil bottle is connected to the cross-tube.2. Fill the pivot shaft bearing compartments with SAE 30W oil until the oil level is at the bottom of the fill hose.3. Install plugs (4).4. Fill the center oil compartment of the pivot shaft through the pivot shaft oil bottle until oil comes out roller frame hole (4).5. Check the oil level in the pivot shaft oil bottle again and fill if necessary.6. The oil level should be checked and maintained daily.(1) Plug must be removed while installing the plate.(2) Torque for 24 5/8 -11 bolts in shaft (earlier) ... 270 40 N m (200 30 lb ft) Torque for 24 bolts 3/4 -10 bolts in shaft (later) ... 475 60 N m (350 45 lb ft)(3) Put 6V-1541 Quick Cure Primer on frame assembly bore and permit to dry. Then put 7M-7456 Bearing Mount on frame assembly bore before seal installation.(6) Torque for bolts that hold idler to bogies (earlier 2YD) ... 2200 200 N m (1620 150 lb ft) Torque for bolts that hold idler to bogies (later 2YD, 3SK):Tighten one bolt to a torque of 2200 200 (1620 150 lb ft).Tighten the second bolt to a torque of 660 65 N m (488 48 lb ft).Insert wedge between the cap assembly and the bogie of the second bolt and tap into place.Tighten the second bolt to a torque of 2200 200 (1620 150 lb ft).(7) Torque for bolts that hold the rollers to the bogies ... 1125 100 N m (820 75 lb ft) (8) Torque for bolts that hold the guide ... 750 80 N m (550 60 lb ft)(9) End of cartridge pin with a 4.8 mm (.19 in) hole or and "X" mark is a larger diameter than the opposite end, and must be installed next to the cap or cover. The hole or "X" mark must be on top or bottom of the vertical centerline.(10) End with a hole or marked "X" must extend from bogie a distance of ... 5.0 0.5 mm (.20 .02 in)