CAGE ASSEM. 2P4411 - Caterpillar

Removal Procedure
Hot engine components can cause injury from burns. Before performing maintenance on the engine, allow the engine and the components to cool.
At operating temperature, the engine coolant is hot and under pressure.Steam can cause personal injury.Check the coolant level only after the engine has been stopped and the fill cap is cool enough to touch with your bare hand.Remove the fill cap slowly to relieve pressure.Cooling system conditioner contains alkali. Avoid contact with the skin and eyes to prevent personal injury.
Raise the hood.
Turn the battery disconnect switch to the OFF position.
Drain the coolant below the level of the head. Refer to Operation and Maintenance Manual, "Cooling System Coolant (ELC) - Change" for the correct draining and filling procedures.
Illustration 1 g03693529
Disconnect tube (1) from the air filter box. Loosen clamp (2) and disconnect tube (3). Discard clamp (2).
Illustration 2 g03693841
Disconnect hoses (4).
Illustration 3 g03693896
Disconnect harness assemblies (5). Remove cable straps (6).
Illustration 4 g03693898
Illustration 5 g03693903
Remove all cable straps along harness assembly (7). Disconnect ether hose (8). Disconnect harness assembly (7).
Illustration 6 g03693912
Remove all cable straps on harness assembly (7). Remove clip (9).
Illustration 7 g03693915
Disconnect harness assembly (7) from the air filter box. Remove all remaining cable straps on harness assembly (7).
Illustration 8 g03693922
Remove heat shield (10).
Illustration 9 g03693951
Attach a suitable lifting device to clean emissions module (11). The weight of clean emissions module (11) is approximately 172 kg (380 lb).
Illustration 10 g03693970
Remove bolt (12). Repeat for the opposite side.
Illustration 11 g03694041
View of right side of the hydraulic tank. Platform removed for photographic purposes.
Place suitable cribbing (X) between the hydraulic tank and the frame in order to support the hydraulic tank when the clean emissions module is removed. Remove bolts (13) from both sides of the hydraulic tank. Remove bolts (14) from both sides.
Remove clean emissions module (11). Installation Procedure
Install clean emissions module (11) in the reverse order of removal.
Tighten harness assemblies (5) to a torque of 1.2 0.20 N m (11 2 lb in).
Replace clamp (2) with a new clamp. Tighten clamp (2) to the following torque 35 2 N m (26 1 lb ft).