CAGE AS 3550168 - Caterpillar

9W9965 Steering And Brake Control Valve
(24) Shims to adjust clutch pressure. (25) Shims to adjust brake pressure. (26) Shims to adjust brake residual pressure. (27) Shims to adjust clutch pressure to 0 to 70 kPa (0 to 10 psi) before brake pressure begins to reduce. (See NOTE beneath Spacer Chart for 6T1171 Control Valve.)
6T1171 Steering And Brake Control Valve
(24) Shims to adjust clutch pressure. (25) Shims to adjust brake pressure. (26) Shims to adjust brake residual pressure. (27) See NOTE beneath Spacer Chart for 6T1171 Control Valve. If the inner spring is secured with a lockring and a cup-shaped retainer, there is no pressure adjustment. Use shims (27) to obtain a clearance of 0.50 0.13 mm (.020 .005 in) between the spring and retainer or shims.Linkage Adjustments
Linkage For Transmission Controls
Transmission control linkage adjustment should be made only with the engine OFF. Accidental transmission engagement and sudden machine movement could cause personal injury.
Torque for 1/4 in. locknuts (10) on cable assemblies (1 and 2) that hold the rod ends in place ... 8 3 N m (6 2 lb.ft.)Torque for 3/8 in. locknuts (7) on rod assembly (8) ... 12 4 N m (9 3 lb.ft.)Torque for all 5/8 in. jam nuts ... 38 7 N m (28 5 lb.ft.)Assembled length of rod assembly (8) ... 202.0 1.5 mm (7.95 .06 in.) All rod assembly measurements must be made in a straight line between the centerlines of the rod end mounting holes.Procedure For Adjustment of Transmission Control Linkage
1. Loosen bolts (4) that hold cover (6) to the housing.2. Loosen locknut (5) for the cable that needs to be adjusted. Turn cover (6) for the cable that needs to be adjusted.
Transmission Control Linkage
(1) Cable assembly. (2) Cable assembly. (3) Guide. (4) Bolts. (5) Locknuts. (6) Cover. (7) Locknuts. (8) Rod assembly. (9) Transmission control lever. (10) Locknuts. To move transmission control lever (9) to either side (right or left), adjust directional cable (2). An adjustment of speed cable (1) will move control lever (9) to the front or rear.3. Adjust control lever (9) so that it does not make contact with guide (3) in any forward or reverse gear or in neutral.Linkage For Steering Clutch And Brake Controls
Do not make any adjustments to the control linkage with the engine running. Accidental disengagement of the parking brake while the engine is running could cause sudden machine movement and personal injury.
Torque for the four bolts that fasten the steering clutch and brake control valve to the case ... 48 4 N m (35 3 lb.ft.)Torque for all 3/8 in. locknuts [jam nuts] that hold the rod ends in place on the rod ... 14 4 N m (10 3 lb.ft.)Torque for 1/2 in. locknuts [jam nuts] that hold the rod ends in place on the rod ... 45 7 N m (33 5 lb.ft.)(A) Assembled length of rod assembly