CAGE-BEARING 3621116 - Caterpillar

VIEW FROM UNDER MACHINE1. Disconnect wires (1) from the torque converter oil temperature sensing unit (2).
VIEW FROM UNDER MACHINE2. Remove four bolts (3) that hold the torque converter outlet relief valve (4) to the torque divider.3. Remove torque converter outlet relief valve (4). Remove the three O-ring seals from the valve.Install Torque Converter Outlet Relief Valve
1. Inspect the O-ring seals for damage and make a replacement if needed. Put the O-ring seals in position on the valve.
VIEW FROM UNDER MACHINE2. Put torque converter outlet relief valve (1) on the torque divider and install the four bolts that hold it in place.
VIEW FROM UNDER MACHINE3. Connect wires (3) to torque converter oil temperature sensing unit (2).end by:a) install floor plate (See OPERATOR'S STATION DISASSEMBLY AND ASSEMBLY section)Disassemble Torque Converter Outlet Relief Valve
start by:a) remove torque converter outlet relief valve
Covers (1) and (2) hold spring (4) under compression.
1. Loosen the bolts that hold cover (2) in place until there is a gap between the cover and the body of about .25 in. (6.35 mm).2. Remove the bolts that hold cover (1) in place and remove the cover from the body.3. Remove cover (2) from the body. 4. Remove one O-ring seal (8) from each end of valve body (12).5. Remove valve spool (5) and spring (4) from the body.6. Remove spacers (9), spiral snap ring (7), retainer (11), spring (6) and poppet (10) from the body.7. Remove plug (3) from the body and remove the O-ring seal from the plug.Assemble Torque Converter Outlet Relief Valve
1. Make sure all of the parts of the valve are clean. Put clean hydraulic oil on all of the parts of the valve. Inspect all O-ring seals for damage and make replacements if needed. 2. Install poppet (3), spring (2) and retainer (1) in valve spool (4) as shown. 3. Install spiral snap ring (5) in the valve spool. 4. Install new O-ring seals on each plug (6) and install the plugs in valve body (9).5. Install the spacers and spring (10) in valve spool assembly (8).6. Install the spool assembly in the body.7. Install O-ring seal (7) on the body. 8. Install cover (11) on the body and start the bolts that hold it in position. 9. Install O-ring seal (13) and cover (12) on the opposite end of the valve body. Install the bolts that hold cover (12) in position.10. Tighten the bolts that hold both covers in place.end by:a) install torque converter outlet relief valve