AVSPARE.COM
parts catalog

CAGE-BEARING-YM 3967261 - Caterpillar



3967261 CAGE-BEARING-YM Caterpillar parts CAGE
Rating:
34
Alternative (cross code) number:
CA3967261
396-7261
3967261
Caterpillar 3967261 CAGE-BEARING-YM
Weight: 18 pounds 8 kg.

Buy CAGE-BEARING-YM 3967261 Caterpillar genuine, new aftermarket tractor parts with delivery

Related part:
1075002  CAGE-BEARING-YM  3967261  CL
  For full view, you need register

Information:

Assembly Procedure
Note: Cleanliness is an important factor. Before assembly, all parts should be thoroughly cleaned in cleaning fluid. Allow the parts to air dry. Wiping cloths or rags should not be used to dry parts. Lint may be deposited on the parts which may cause later trouble. Inspect all parts. If any parts are worn or damaged, use new parts for replacement. Dirt and other contaminants can damage the precision components. All disassembly and all assembly procedures must be performed on a clean work surface and in a clean area. Keep cleaned parts covered and protected at all times.
Illustration 1 g00746184
Illustration 2 g01665617
Install retainer (19) , spring (20) , poppet (21) , sleeve (22) , slug (23) and snap ring (24) in spool assembly (15) .
Install spool assembly (15) , spring (16) , stop (18) and adjuster assembly (17) to a torque of 25 4 N m (18.0 3.0 lb ft).
Illustration 3 g00746182
Illustration 4 g00746181
Note: O-rings, gaskets, and seals should always be replaced. A used O-ring may not have the same sealing properties as a new O-ring. A reconditioning procedure should not be degraded because of a low cost component such as an O-ring or a gasket. Use 1U-6396 O-Ring Assembly Compound during the assembly procedure.
Install O-ring seals (14) on cartridge assembly (10) .
Install coil (11) , washer (12) , and nut (13) . Tighten nut (13) to a torque of 20 2.5 N m (15.0 1.0 lb ft).
Install solenoid assembly (9) in the priority valve. Tighten solenoid assembly (9) to a torque of 50 5 N m (37.0 4.0 lb ft).
Illustration 5 g00746180
Illustration 6 g00746179
Install O-rings (4) , (5) and (7) .
Install dowel (8) and ball (6) .
Install valve assembly (3) in priority valve (2) .
Illustration 7 g00746177
Install O-rings (1) .End By: Install the priority valve. Refer to Disassembly and Assembly, "Priority Valve - Install".


Parts cage Caterpillar catalog:

Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.