CAGE 4L7584 - Caterpillar

Removal Procedure
Table 1
Required Tools    
Tool    Part Number    Part Description    Qty    
ZZ     8S-4950     Caps     6    
9S-8927 Plugs     6    Start By:
Install the steering frame lock. Refer to Disassembly and Assembly, "Steering Frame Lock - Remove and Install".
Release the hydraulic system pressure. Refer to Disassembly and Assembly, "System Pressure - Release".
Remove the seat. Refer to Disassembly and Assembly, "Seat - Remove and Install".Note: SERVICE DATA: TOOLING (ZZ) WILL NOT BE IDENTIFIED IN PHOTOGRAPHS IN THE REMOVAL OR THE INSTALLATION. THIS TOOLING IS SHOWN IN ORDER TO ASSIST THE EXPERIENCED SERVICEMAN.Note: Put identification marks on all hoses, on all hose assemblies, on all wires, and on all tube assemblies for installation purposes. Plug all hose assemblies and plug all tube assemblies. This helps prevent fluid loss, and this helps keep contaminants from entering the system.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
Personal injury can result from hydraulic oil pressure and hot oil.Hydraulic oil pressure can remain in the hydraulic system after the engine has been stopped. Serious injury can be caused if this pressure is not released before any service is done on the hydraulic system.Make sure all of the work tools have been lowered to the ground, and the oil is cool before removing any components or lines. Remove the oil filler cap only when the engine is stopped, and the filler cap is cool enough to touch with your bare hand.
Illustration 1 g01097519
Remove covers (1), (2) and (3) .
Illustration 2 g01097520
Remove cover (5) and disconnect electrical connector (9) .
Disconnect six hose assemblies (8) and remove the six fittings from pilot control valve (7) .
Remove four screws (6) .
Remove pilot control valve (7) and lever (4) .
Illustration 3 g01097895
Remove electrical connector (9). For instructions on servicing Deutsch connectors refer to Special Instruction, SEHS9615.
Pull the wiring harness through the hole in pilot control valve (7) and remove grommet (11) .
Loosen nut (10) and remove lever (4) from pilot control valve (7).
Remove nut (10) from lever (4) .