CAGE AS 8D5106 - Caterpillar

Illustration 121 g00961507
Install friction discs (15), clutch plates (14), and end plate (13).
Illustration 122 g00961492
Install retaining ring (12).
Illustration 123 g00961468
Install retaining ring (11).
Illustration 124 g03730131
Illustration 125 g00744313
Typical Example
(W) End plate. (X) Retaining ring. (Z) Oil passage. (Y) Running clearance.
Use Tooling (L), a suitable air supply, and the following procedure to measure the running clearance of the clutch pack:
Place the shaft in the vertical position. End Plate (W) that will be measured should be facing upward.
Make sure that End Plate (W) is free.
Position the tip of Tooling (L) on End Plate (W). Zero Tooling (L).
Personal injury can result from applying air pressure without the lock ring securely in place. If the lock ring is not secure, the end plate and discs can suddenly come out with great force. Make sure lock ring is securely in place before applying air pressure to clutch pack.
Apply air pressure of approximately 140 kPa (20 psi) to appropriate Passage (Z) in the shaft for the clutch that is being checked.
End Plate (W) should move upward and End Plate (W) should contact Retaining Ring (X). The dial indicator will display the distance between End Plate (W) and Retaining Ring (X). This distance is the running clearance of the clutch pack. Refer to Table 2 for the correct running clearance.
Illustration 126 g00961455
Install retainer (10) and thrust disc (9) .
Illustration 127 g00961444
Use Tooling (G) to install retaining ring (6).
Connect hub (7) and gear (5). If necessary, install sleeve bearing (8).
Illustration 128 g00961435
Install gear and hub assembly (5).
Illustration 129 g00961189
Use Tooling (D) to install retaining ring (3) and install thrust disc (4).
Illustration 130 g00961151
Position shaft (1) on Tooling (C), as shown.
Illustration 131 g00984312
Install Tooling (A) to shaft (1). Attach a suitable lifting device to Tooling (A).Note: Hold input shaft (2) away from shaft (1) for clearance.
Use a suitable lifting to lower shaft (1) straight up out of transmission case. The weight of shaft (1) is approximately 50 kg (110 lb).Note: Connect the transmission and the torque converter.
Illustration 132 g03729914
Use shims to obtain a thickness of 0.05 mm to 0.15 mm (0.002 inch to 0.006 inch). Use Tooling (L) to check the end play on the output shaft and the input shaft.
Illustration 133 g03729921
Use shims to obtain a thickness of 0.05 mm to 0.15 mm (0.002 inch to 0.006 inch). Use Tooling (L) to check the end play on the input shaft.End By:
Connect the transmission to the torque converter.