CAGE 8M0476 - Caterpillar

Receiving Inspection
If the generator is received during cold weather, allow the unit to reach room temperature before you remove the protective packing material. Warming the generator to room temperature will prevent the following problems:
Water condensation on cold surfaces
Early failures due to wet windings
Early failures due to wet insulating materialsUnpacking
Moving the Generator
Improper lift rigging can allow unit to tumble causing injury and damage.
Do not use the engine lifting eyes to remove the engine and generator together.
Unpack the equipment with care in order to avoid scratching painted surfaces. Move the unit to the mounting location. Follow the instructions under the "Product Lifting" topic. The hoist and the hoist cables should have a rating that is greater than the weight of the generator.Location
The location of the generator must comply with all local regulations. The location of the generator must also comply with all special industrial regulations. Locate the generator in an area that meets the following requirements:
Clean
Dry
Well-ventilated
Easily accessible for inspection and maintenanceDo not obstruct air inlet openings. Do not obstruct discharge openings. Air flow must reach these openings. If the generator is exposed to harsh environmental conditions, the generator can be modified in the field in order to add filters and space heaters. In addition, a more rigid periodic maintenance schedule should be established.Note: For further information concerning the installation of this generator set, see the appropriate Application and Installation Guide.Protective Devices
The output to the load of the generator should always be protected with an overload protection device such as a circuit breaker or fuses. Fuses should be sized by using the lowest possible current rating. However, this rating must be above the current rating for full load. A common recommendation is 115 percent of rated current. Determine the size of fuses or determine the size of circuit breakers in accordance with NEMA, IEC, and Local Electrical Codes.Storage
If the generator is not installed immediately, refer to the "Product Storage" topic for the proper considerations for storing the unit.Isolator Installation
Illustration 1 g03390662
(1) Top plate
(2) Adjusting bolt
(3) Locknut
(4) Spacer shim
(5) Locknut
(6) Base plate
(7) Anchor hole
Read all installation instructions prior to installing.
Isolators are shipped fully assembled. Position isolators in accordance with installation drawings or as otherwise recommended.
Set Isolators on floor, housekeeping base, or sub base. Ensure that all isolator center lines match the Generator Set mounting holes. Installing the base plates (6) on a level surface is recommended. Shim or grout as required, leveling all isolator base plates at the same elevation. Maximum difference in elevation is 0.6 cm (0.25 inch).
Mark anchor hole locations (7) as indicated on base plate footprint prior to drilling.
Anchor all isolators to the floor, housekeeping pad, or sub base using thru holes as required. Use appropriate anchors that meet design requirements. Welding to steel is permitted providing the weld achieves the required strength and appropriate measures have been taken to protect the Generator Set from damage.
Isolators are shipped with two removable spacer shims (4) between the top plate and housing. These shims must be in place when the Generator Set