CAGE-BEARING 9P6282 - Caterpillar

Introduction
Do not perform any procedure in this Special Instruction until you read this information and you understand this information.Before replacing any C9 high pressure fuel line, follow the instructions that are listed below.Note: The following procedures were written for the complete removal of all of the fuel lines and clamps. If only specific fuel lines need to be replaced then only remove the fuel lines and clamps that need replacement.Note: Failure to follow this procedure may result in a leaking fuel line.Safety Section
Contact with high pressure fuel may cause fluid penetration and burn hazards. High pressure fuel spray may cause a fire hazard. Failure to follow these inspection, maintenance and service instructions may cause personal injury or death.
Contact with high pressure fuel may cause personal injury or death. Wait 60 seconds after the engine has stopped to allow fuel pressure to purge before any service or repair is performed on the engine fuel lines.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
Fuel injection lines MUST only be used once. Discard all fuel injection lines after use.
Fuel Line Removal and Installation Procedures
Required Parts
Table 1
Fuel Line Part Number     Description     Replacement Kit Part Number     Description    
292-3740     Fuel Line Tube Assembly     310-6031     Fuel Lines Kit    
284-9380     Fuel Line Tube Assembly     310-6032     Fuel Lines Kit    
308-7062     Fuel Line Tube Assembly     310-6033     Fuel Lines Kit     Replace the removed high pressure fuel line with the corresponding Fuel Lines Kit. The clamp, the grommet, and the new fuel line that is supplied with the Fuel Lines Kit must be used as the replacements for the old parts. Refer to Table 1.Note: Do not reuse the old clamp, the old grommet, and the old fuel line.Removal Procedure
Turn the fuel supply to the OFF position.
Disconnect the battery. Refer to Operation and Maintenance Manual, "Battery or Battery Cable - Disconnect".
Illustration 1 g01444743
Illustration 2 g01630113
(7) Grommet (8) Clamp (9) Bolt
Remove the bolts (9) and clamps (8) at locations (1), (2), (3), and (4). Take note of the rubber grommets (7) in clamps (8) at locations (1), (2), (3), and (4) .
Loosen nut (6) on each end of fuel line (5). Remove fuel line (5). Repeat for the remaining fuel lines. Discard the fuel lines.Installation Procedure
Illustration 3 g01444743
Install a new fuel line (5). Hand tighten nut (6) on each end of the fuel line. Repeat for the remaining fuel lines.
Install clamps (8) at locations (1), (2), (3), and (4). Make sure that the rubber grommets (7) are placed correctly in clamps (8) at locations (1), (2), (3),