CAGE-PINION BEARING 9S3321 - Caterpillar

Engine exhaust contains products of combustion which may be harmful to your health. Always start and operate the engine in a well ventilated area and, if in an enclosed area, vent the exhaust to the outside.
When the engine is in the AUTOMATIC mode, the engine can start at any moment. To avoid personal injury, always remain clear of the the engine when the engine is in the AUTOMATIC mode.
Before manually starting the engine, perform all of the procedures that are described in this Operation and Maintenance Manual, "Before Starting Engine". Ensure that no one will be endangered before the engine is started and when the engine is started.
Do not engage the starting motor when flywheel is turning. Do not start the engine under load.If the engine fails to start within 30 seconds, release the starter switch or button and wait two minutes to allow the starting motor to cool before attempting to start the engine again.
For initial start-up of a new or rebuilt engine, and for start-up of an engine that has been serviced, make provision to shut the engine off should an overspeed occur. This may be accomplished by shutting off the air and/or fuel supply to the engine.
Start the engine by one of these three methods.
The operator presses the "RUN" Key.
The control is in "AUTO" and the remote initiate contact (IC) becomes active.
The operator presses the "AUTO" Key and a start command is sent via the RS-485 SCADA Data Link.
The EMCP 4 checks the system before the crank cycle begins. The EMCP 4 checks that no system faults are present. The EMCP 4 checks that all previous shutdown faults have been reset. The EMCP 4 also checks that the engine is not already running. If the engine is equipped with prelube, the EMCP 4 checks the status of the prelube. If the prelube is not complete, the EMCP 4 will not crank the engine.
The EMCP 4 begins the crank cycle.
The EMCP 4 cranks the engine until the crank cycle time reaches the setpoint for total crank time or until the engine starts.
The EMCP 4 deactivates the starting motor relay (SMR) when the engine speed reaches the setpoint for crank terminate speed.