CALIPER-BRAKE 5299163 - Caterpillar

Illustration 1 g02636436
Table 1
Specification for 144-3527 Flywheel Housing Gp
Item Qty Part Specification Description
Before installation of the flywheel housing, inspect the following components for any foreign materials: The front face of the flywheel housing, the two sides of the flywheel housing gasket and the rear face of the cylinder block. These components must be free of the following substances: oil, fuel, water, gasket adhesive, assembly compounds, and any other foreign material. Apply ultra blue Loctite 587 to fill the joints of the cylinder block, flywheel housing, and engine oil pan.
1 1 5J-5793 Bolt Use the following procedure to tighten the bolts of the flywheel housing:
1.Tighten bolt 1 through bolt 9 in the numerical sequence as shown in Illustration 1 to 100 20 N m (75 15 lb ft).
2. Tighten bolt 10 through bolt 22 in the numerical sequence as shown in Illustration 1 to 40 10 N m (30 7 lb ft).
3. Again, tighten bolt 1 through bolt 9 in the numerical sequence as shown in Illustration 1 to 135 20 N m (100 15 lb ft).
4. Again, tighten bolt 10 through bolt 22 in the numerical sequence as shown in Illustration 1 to 55 10 N m (41 7 lb ft).
2 8 9K-7290 Bolt
3 6 165-3930 Bolt
4 2 165-3936 Bolt
5 5 165-3932 Bolt