CAMERA AR 3943199 - Caterpillar

Removal Procedure
Start By:
Remove fuel filter housing.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat® products.Dispose of all fluids according to local regulations and mandates.
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 1 g03845624
Remove bolts (1).
Illustration 2 g03845636
Remove bolts (2).
Illustration 3 g03845661
Remove bolts (5), guard assembly (4), and guard assembly (6).
Illustration 4 g03845922
Remove bolts (7) and guard assembly (8).
Illustration 5 g03845959
Remove bolts (9) and plate (10).
Illustration 6 g03845982
Disconnect harness assemblies (11). Remove pressure sensor (12) and pressure sensor (13).
Illustration 7 g03846145
Remove bolts (14) and plates (15).
Illustration 8 g03846279
Disconnect coupling assembly (17), coupling assembly (19), tube assembly (16), and tube assembly (18).
Illustration 9 g03846303
Remove bolt (21) and clamps (22). Disconnect tube assembly (20).
Illustration 10 g03846476
Remove bolts (23) and regulator housing (24).
Illustration 11 g03846487
Use a suitable lifting device to remove engine oil filter housing (25). The weight of engine oil filter housing (25) is approximately 55 kg (121 lb).
Remove bolts (26) and engine oil filter housing (25). Installation Procedure
Install engine oil filter housing (25) in the reverse order of removal.
Tighten bolts (14) to a torque of 135 20 N m (100 15 lb ft).
Tighten pressure sensor (13) and pressure sensor (12) to a torque of 10 2 N m (86 180 lb in).