CAMERA & MOUNTING GP 5027217 - Caterpillar

Illustration 1 g01439077
System schematic for CCM data linkNote: When a Customer Communication Module (CCM) is connected to a single genset, the positive battery terminal "BATT+" is connected directly to TS-BATT+. When a CCM is connected to multiple gensets, connect the CCM to TS-73, and ensure that a wire is added between TS-73 on all generator sets. On gensets that are equipped with a CCM, the GSC+P uses the "CCM data link" to communicate with the CCM. The CCM data link consists of two wires that connect the GSC+P to the CCM. The possible causes of a CID 0770 FMI 09 are listed below.
A short to "BATT+" from either one of the two connector pins, 21 or 22
A short from the negative battery terminal ("BATT-") to either of the two connector pins, 21 or 22Note: The GSC+P cannot detect an open in the circuit of the CCM data link. The GSC+P treats a CID 0770 as an alarm fault. Active alarm faults are shown on the display when the "Alarm Codes" key is pressed and the Engine Control Switch (ECS) is in any position except the OFF/RESET position. Troubleshoot and repair the wiring. Refer to Testing and Adjusting, "Schematics and Wiring Diagrams". Clear the fault from the fault log after troubleshooting is complete. Test Step 1. CHECK THE CCM FOR A SHORT TO "BATT+"
Turn the ECS to the OFF/RESET position.
Disconnect the "BATT+" and "BATT-" battery leads from the battery.
Measure the resistance between pin 21 and "BATT+".
Measure the resistance between pin 22 and "BATT+".Expected Result:The resistance is greater than 5000 ohms for both cases.Results:
OK - The resistance is greater than 5000 ohms for both cases. The circuit is correct. Proceed to Test Step 2.
NOT OK - The resistance is less than 5000 ohms. The