CAMSHAFT AS-RR 10R0667 - Caterpillar

Linkage For Clutch Control Group
Torque for all 1/2 in. locknuts that hold the rod ends in place on the rods ... 45 7 N m (33 5 lb ft)Assembled length of rod assembly (5) ... 367 2 mm (14.4 .08 in.) Measure the length in a straight line between the centerlines of the rod end pin holes.
Clutch Control Linkage
(1) Lever. (2) End (rod). (3) Rod. (4) Pedal (clutch). (5) Rod assembly. (6) End (rod).Adjustment Procedure for the Clutch Control Linkage
1. Install clutch pedal (4) so that the centerline of slot (7) is one spline tooth down (clockwise) from the timing mark on the shaft. To bring the pedal closer to the operator, align the timing mark on shaft with the centerline of slot (7).2. Install rod ends (2) and (6) on rod (3) and install assembled rod (3) and rod assembly (5) on the tractor.3. Move lever (1) counterclockwise until it stops and hold it in this position during Step 4.4. Measure distance (A) from the brake support to the end of clutch pedal (4). Distance (A) must be 282 14 mm (11.1 .6 in.)
Clutch Control Linkage
(4) Pedal (clutch). (A) 282 14 mm (11.1 .6 in.). (B) 310 12 mm (12.2 .5 in.) Measure distance (B) to bring pedal closer to operator. Distance (B) must be 310 12 mm (12.2 .5 in.).5. If distance (A) or (B) is too short, make assembled rod (3) shorter. If distance (A) or (B) is too long, make rod (3) longer.
Clutch Control Linkage.
(7) Slot. (8) Lever.Linkage For Transmission Interlock
To prevent possible injury, make adjustments with the engine off and the parking brake activated.
Transmission Interlock Linkage
(1) Plunger. (2) Shaft (interlock). (3) Rod assembly. (4) Nut.Adjustment Procedure for the Interlock Linkage
1. Adjust rod assembly (3) so that the centerline length between the rod end pin holes is ... 277 1 mm (10.9 .04 in)2. Install rod assembly (3) between the two levers but do not tighten nut (4).3. Make sure all three speed shift shafts and the direction shift shaft are in their NEUTRAL positions.4. Move any one of the shift shafts to a speed or direction position. Then move the shift shaft back toward the neutral notch until it is directly in between the two notches. Keep the shift shaft in this position during Step 5.5. Adjust rod assembly (3) until the flat on interlock shaft (2) makes contact with the stem of plunger (1).6. Tighten nut (4) and move the shift shaft back to its NEUTRAL position. Nut (4) has left hand threads and must be turned counterclockwise to tighten it.Linkage For Clutch And Transmission Brake Control Valve
Control Valve Linkage
(1) Dimension (calculated). (2) Link. (3) Dimension 0.08 0.08 mm (.003 .003 in.). (4) Roller. (5) Pin. (6) Lever. (7) Switch. (8) Spool (brake valve). (9) Piston (clutch). (10) Link.Adjustment Procedure for Valve Linkage
Adjustments must be made with the valve removed from the tractor.1. Pull