CAMSHAFT GROUP 1113770 - Caterpillar

Installation Procedure
Table 1
Required Tools    
Tool    Part Number    Part Description    Qty    
A     9S-9082     Engine Turning Tool     1    
B     200-3914     Piston Ring Compressor     1    
C     4C-5593     Anti-Seize Compound     1    
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Apply clean engine oil to the pistons, the piston rings, and the cylinder liners.
Use Tooling (A) to position the rod bearing journal that is being serviced in the bottom center position.Note: The number on the bearing cap must be on the same side as the connecting rod. The number on the bearing cap must match the number on the connecting rod.
Illustration 1 g01096076
Use Tooling (B) and a soft hammer to install piston (2) and the connecting rod in the cylinder liner.
Illustration 2 g01096077
The connecting rod and the piston must be installed in the engine with Surface (X) toward the crankshaft main bearing journal. Surface (Y) must be toward the connecting rod.Note: Surface (X) is thicker than Surface (Y) .Note: Surface (X) is chamfered in order to fit the crankshaft.
Illustration 3 g00568813
Apply Tooling (C) to the threads of the bolts on the connecting rod. Install the bearing cap and the nuts. Tighten nuts (1) on the bearing cap to a torque of 82 8 N m (60 6 lb ft). Place a mark on each nut and on each bearing cap. Tighten each nut for an additional 120 5 degrees.End By:
Install the engine oil pump. Refer to Disassembly and Assembly, "Engine Oil Pump - Install".
Install the cylinder head. Refer to Disassembly and Assembly, "Cylinder Head - Install".