CAMSHAFT-FUEL PUMP 1155700 - Caterpillar

Personal injury can result from hydraulic oil pressure and hot oil.Hydraulic oil pressure can remain in the hydraulic system after the engine has been stopped. Serious injury can be caused if this pressure is not released before any service is done on the hydraulic system.Make sure all of the work tools have been lowered to the ground, and the oil is cool before removing any components or lines. Remove the oil filler cap only when the engine is stopped, and the filler cap is cool enough to touch with your bare hand.
Personal injury or death can result from improperly checking for a leak.Always use a board or cardboard when checking for a leak. Escaping air or fluid under pressure, even a pin-hole size leak, can penetrate body tissue causing serious injury, and possible death.If fluid is injected into your skin, it must be treated immediately by a doctor familiar with this type of injury.
Illustration 1 g00104545
Prevent the machine from movement. Park the machine on a level surface.Attach a "Do Not Operate" warning tag to the start switch before you service or repair the equipment. These warning tags (Special Instruction, SEHS7332) are available from your Caterpillar dealer.Required Parts
Table 1
Parts List for 356-3683 Boom Lines Gp - 00    
Item     Qty     Part No.     Description    
(1)     1     208-4538     Hose As    
(2)     2     290-7574     Hose As    
(3)     1     208-4537     Hose As    
(4)     1     206-9665     Plate    
(5)     6     132-9176     Plate    
(6)     2     206-9666     Plate    
(7)     6     7X-2554     Bolt    
(8)     8     8T-4137     Bolt    
(9)     10     8T-4175     Bolt    
(10)     6     6V-1889     Clip    
(11)     6     8T-4121     Hard Washer    
(12)     6     7J-9108     O-Ring Seal    
(13)     4     6V-8996     Union    
(14)     4     6V-9170     Bulkhead Nut    
(15)     30     7K-1181     Cable Strap    
Illustration 2 g03582998
Installation Procedure
Illustration 3 g03583716
(A) Area A (B) Area B
Illustration 4 g03583722
Area C
Illustration 5 g03583718
Area D
Install hoses, plates, clips, and seals as shown.
Tighten all fittings to standard torque.
Check for leaks.