CAMSHAFT GP 2230069 - Caterpillar

2230069 CAMSHAFT GP Caterpillar parts 301.6C

Price: query

Add in request price Go to cart

Rating:

Alternative (cross code) number:
CA2230069
223-0069
2230069

Buy CAMSHAFT GP 2230069 Caterpillar genuine, new aftermarket tractor parts with delivery
MINI HYD EXCAVATOR,

Compatible equipment models: 2230069:

MINI HYD EXCAVATOR 301.6C Caterpillar

Number on catalog scheme:

Caterpillar 2230069 Parts scheme CAMSHAFT GP

For full view, you need register

Caterpillar SIS machinery equipment:

Caterpillar SIS

301.6C & 301.8C Mini Hydraulic Excavators JBB00001-UP (MACHINE) POWERED BY L3E Engine » 223-0069 CAMSHAFT GP

Caterpillar parts catalog:

Caterpillar parts catalog
Product:

301.6C & 301.8C Mini Hydraulic Excavators JBB00001-UP (MACHINE) POWERED BY L3E Engine

243-7063: ENGINE AR-PRIMARY » SEBP42290015
303-2860: ENGINE AR-PRIMARY » SEBP42290016

Information:

Illustration 1 g00440146
Schematic for the Tilt Dump Solenoid
This diagnostic code is recorded when the implement electronic control module (ECM) determines that the solenoid valve is out of calibration.The possible causes for this diagnostic code are listed:
New software has been flashed.
The calibration of the valve has failed.System Response:The machine response is listed:
The implement features will not operate efficiently.Note: Ensure that the diagnostic code is active and that the diagnostic code indicator is active.Test Step 1. CHECK CALIBRATION.
Calibrate the main control valve. See Testing and Adjusting, "Main Control Valve (Electronic Technician) - Calibrate" or Testing and Adjusting, "Main Control Valve (Operator Monitor) - Calibrate".
Recheck the diagnostic code.
Ensure that the diagnostic code is active.
Observe the ON/OFF status of the diagnostic code indicator as the work tool is tilted back fully and the work tool is dumped. Expected Result:The diagnostic code indicator is inactive.Results:
YES - The diagnostic code indicator is inactive.Repair: The diagnostic code is not active now. Calibration corrected the diagnostic code. Clear the diagnostic code. STOP
NO - The diagnostic code indicator is active.Repair: It is unlikely that the ECM has failed. Perform calibration for the Main Control Valve again. Also, ensure that the diagnostic code indicator is active for this diagnostic code. If the cause is not found, replace the solenoid and perform the calibration again. If this does not eliminate the diagnostic code, replace the ECM. See Testing and Adjusting, "Electronic Control Module (ECM) - Replace".STOP