CAMSHAFT GP 2237460 - Caterpillar

Installation Procedure
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Note: Cleanliness is an important factor. Before assembly, thoroughly clean all parts in cleaning fluid. Allow the parts to air dry. Do not use wiping cloths or rags to dry parts. Lint may be deposited on the parts which may cause trouble. Inspect all parts. If any parts are worn or damaged, use new parts for replacement. Dirt and other contaminants can damage the precision component. Perform assembly procedures on a clean work surface. Keep components covered and protected at all times.
Illustration 1 g01383383
Lubricate new seal (8) with clean engine oil. Install seal (8) on fuel transfer pump (2) .
Illustration 2 g01383340
Position fuel transfer pump (2) and install bolts (3). Tighten bolts (3) to a torque of 30 2 N m (22 1 lb ft).
Install new washers and connect hose assemblies (5) .
Install nut (4). Tighten nut (4) to a torque of 34 4 N m (25 3 lb ft).
Connect hose assembly (1) .
Position bracket (7) and install bolts (6). Tighten bolts (6) to a torque of 60 6 N m (44 4 lb ft).