CAMSHAFT AS 4522502 - Caterpillar

Modification Procedure
The chart lists the components required for the modification.
1. Relieve the tension on the alternator drive belt. Remove the Ford adjusting bolt (Ford Part No. E5HT- 10C344-BA) that is used to apply tension to the alternator drive belt. Retain the nuts (3) used on the former adjusting bolt and the nut (4) and washers (5) used on the bolt that fastened the former adjusting bolt to the alternator support bracket.2. Drill a 14.29 mm (.562 in) (9/16 in) hole through the Ford fan support bracket at the location shown in Illustration 1. The fan support bracket may have to be removed from the engine before the new hole is drilled.3. Install the new adjusting bolt (1) (Ford Motor Co. Part No. F2HT-10C344 or Caterpillar Part No. 9L6371).
Illustration 1. Location for the new 14.29 mm (.562 in) (9/16in) diameter hole to be drilled through the fan support bracket.The eye in the new adjusting bolt goes on the rear side of the fan support bracket (6) over the new hole that was drilled in Step 2. Install the new bolt (2) (Ford Motor Co. Part No. 58677-S2 or Caterpillar Part No. 0S1587) through the new hole in the fan support bracket (6) and the eye of the new adjusting bolt (1). Use the nut (4) and washers (5) that were retained to install the new bolt (2). Use nuts (3) that were retained on adjusting bolt (1).
Illustration 2. Location of new components. (1) Adjusting Bolt, Ford Motor Co. Part No. F2HT-10C344 or Caterpillar Part No. 9L6371. (2) Bolt, Ford Motor Co. Part No. 58677-S2 or Caterpillar Part No. 0S1587. (3) Retained Nuts. (4) Retained Nut. (5) Retained Washers. (6) Modified fan support bracket4. Adjust the alternator drive belt tension and tighten all nuts and bolts.