CAMSHAFT GP 4P6895 - Caterpillar

Traction Control
Illustration 34 g03774540The Traction Control screen will enable the user to view the different axles solenoid current percentages. The screen also contains the machine slope in percentage. The percentages are denoted by the white arrow gliding over a green bar graph. The four graphs correspond to the following axles respectively:
Front Cross Axle
Inter axle Lock
Center Cross Axle
Rear Cross AxleThe Machine slope is indicated by the icon as shown in the picture with the value next to it. The range for the machine slope is from -100% to 100% .The values for the parameters change based on the percentage values received from the chassis ECM. If there is a fault value received, then a red triangle is displayed instead of the value and the white triangle disappears for that particular parameter.Operator Menu
Illustration 35 g03426174
Operator Menu Screen
The Operator screen will appear when the operator presses the "OK" button while highlighting Operator on the Main Menu screen, or when "Back" is pressed from deeper within the menu structure. The purpose of this screen is to provide navigation to functions involving the operator feature. This screen contains a Menu List (with icons) populated by Select and Edit. Pressing "OK" will navigate to the appropriate screens. Pressing the "Back" button will navigate to the Main Menu screen. Operator Selection
The Select screen will appear when the operator presses the "OK" button while highlighting "Select" on the Operator screen. The purpose of this screen allows the active operator to be set. This screen will contain a list of stored operator profile names. If the user presses "OK", the highlighted operator profile should activate. A confirmation message will be displayed"Operator XXXXX Applied". After the confirmation popup is displayed for 3 seconds, the display will return to the Operator screen. If "Back" is pressed, the previous settings are retained, and the display will return to the Operator screen.Edit Operator
Illustration 36 g03426175
Edit Operator Screen
The Edit screen will appear when the operator presses the "OK" button while highlighting "Edit" on the Operator screen, or at the Startup Screen. The purpose of this screen is to provide the ability to edit existing operator namesCamera Menu
The Rear Vision Camera screen may be entered in two ways.
Illustration 37 g03426176
Main Menu
Rear Vision Camera can be found in the main menu. If the camera screen is shown in this fashion, pressing "Back" will cause the display to navigate back to the main menu.
Illustration 38 g02152333
Rear Camera View
If the machine is placed in reverse, this screen will be shown automatically. This screen may only be exited when the machine is taken out of reverse.Payload Menu
Illustration 39 g03792594
Payload Menu
The main display screen will show automatically when the weighing system detects that more than 5000 kg (11023 lbs) has been loaded into the dump body. The upper left-hand side of the screen dynamically displays the current payload. The bar of lights, below the ejector body symbol, visually represents the progress of the loading cycle and matches the lighting information presented to the loading tool operator by the external loading lights. There are two