CAMSHAFT 7C0667 - Caterpillar

Illustration 18 g06147907
Illustration 19 g06147935
Illustration 20 g06147958
Illustration 21 g06150879
Illustration 22 g06148399
Tighten bolts (22.2) until bolts are finger tight.
Illustration 23 g06150899
Illustration 24 g06148425
Illustration 25 g06150923
Illustration 26 g06148458
Illustration 27 g06148495
Illustration 28 g06148027
Tighten two bolts opposite from each other to a torque of 34 N m (300 lb in). Rotate center shaft for three revolutions to properly seat bearings. Repeat this step until torque on the two bolts stabilizes. Repeat this process for the remaining two cages. Install shims achieving end play of 0.050 mm (0.002 inch) + 0.05 mm (0.002 inch) - 0.0127 mm (0.0005 inch).
Illustration 29 g06150956
Illustration 30 g06148535
Once all shims and O-Rings are installed and endplay is achieved torque all bolts.
Illustration 31 g06148545
Illustration 32 g06148556
Illustration 33 g06148560
Illustration 34 g06148565