AVSPARE.COM
parts catalog

CANOPY 077044 0877044 - Caterpillar



0877044 CANOPY 077044 Caterpillar parts CANOPY
Rating:
76
Alternative (cross code) number:
CA0877044
087-7044
0877044
Caterpillar 0877044 CANOPY 077044

Buy CANOPY 077044 0877044 Caterpillar genuine, new aftermarket tractor parts with delivery

  For full view, you need register

Information:


Diesel engine exhaust contains products of combustion which may cause personal injury.Always start and operate the engine in a well ventilated area, and, if in an enclosed area, vent the exhaust to the outside.
Specifications
Table 1
Machine Test Parameters
Date Product or Component SN
Measurement Location Measurement Actual
Crown chain maximum deflection. 6 mm (0.25 inch) Introduction
This procedure outlines the method to check and adjust the tension of the drive chain for the crown control. Test Preparation
Drive the machine to a smooth, horizontal surface. Refer to the tractor Operation and Maintenance manual for the proper operating procedure.
Illustration 1 g03670060
Raise the screed and allow the tow arms to rest on two arm supports (1).
Shut the engine off.
Illustration 2 g03672899
Move bridging grate (2) to the stored position. Secure the bridging grate in the stored position with pin (3).
Illustration 3 g03672926
Remove one bolt (5) and washer from the front two screed grates (4).
Illustration 4 g03672931
Remove the front two screed grates (4). Test Procedure
Illustration 5 g03672948
Check the tension of crown chain (6). The crown chain should have a maximum deflection of 6 mm (0.25 inch) on the longest length. If the deflection of the crown chain is out of specification, go to "Adjustment Procedure". If the crown chain is within specification, go to Step 2.
Position the two front screed grates (4). Secure the screed grates with bolts (5) and two washers.
Remove pin (3) and lower bridging grate (2). Adjustment Procedure
Illustration 6 g03672980
Loosen four locking bolts (7).
Turn adjustment bolt (8) in order to adjust the tension of crown chain (6). The crown chain should have a maximum deflection of 6 mm (0.25 inch) deflection on the longest length.
Tighten four locking bolts (7).


Parts canopy Caterpillar catalog:

Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.