CANOPY AS 3091204 - Caterpillar

Illustration 4 g02139495
View in pump compartment
Locate the solenoid valve inside the pump compartment.
Make three terminal connections with wire harness (6) to the solenoid valve.
Fasten clip (7) on to solenoid valve support using washer (10) and bolt (13). Secure wire harness (6) to clip (7). Use strap (1) .
Illustration 5 g02139508
View in pump compartment
Fasten the ground terminal "235 BK" to the existing bulkhead prior to routing harness through the opening.
Route wire harness (6) through the opening in the right-hand frame rail of the machine.Note: Two terminals "K872 OR", "200 BK" should not route through the frame rail. This portion of the wire harness will be installed last.
Illustration 6 g02139780
View of main control valve
Illustration 7 g02139522
Detail A
Route terminal "G973 OR", "235 BK" along the back side of the main control valve up to the pressure switch located on port "aL4". The pressure switch is located on the upper left-hand side of the main control valve.
Make the terminal connection to the pressure switch.
Illustration 8 g02139798
View of engine room
Make the ground connection to the bulkhead in between the engine compartment and the main control valve compartment.
Illustration 9 g02139813
View of engine room
Route wire harness with terminal connections "147 PU", "G973 OR", "K866 WH", "K871 WH" along the backside of the engine compartment, to the chassis harness. Make terminal connections to the chassis harness.
Illustration 10 g02139843
View of battery room
Illustration 11 g02139850
View of battery room
Make terminal connection to the cab harness.
Fasten clip (4) to terminal inside the battery compartment. Remove the bolt securing clip for the platform harness. Place clip (4) and the clip for the platform harness together. Fasten in place with the existing bolt.
Illustration 12 g02139854
Route the remaining portion of the wire harness along the outside of the right-hand frame rail toward the front of the machine.
Route harness through the opening in the right-hand frame rail next to the foot of the boom.
Illustration 13 g02139954
Valve - right hand
Make the terminal connection to the solenoid valve, located on the right-hand frame rail.
Fasten clip (9) onto the support below the solenoid valve. Use washer (10) and bolt (13). Secure the wire harness to clip (9). Use strap (1) .
Fasten the ground "200 BK" to the existing ground point located on the right-hand frame rail, next to the opening in the frame rail.
Illustration 14 g02139974
Valve - left hand
Route the remaining portion of the wire harness across the boom foot, to the solenoid valve located on the left-hand side of the frame.
Make terminal connection to solenoid.
Remove the bolt securing hose clip to support below the solenoid valve. Place clip (3) onto the hose clip and secure to the frame with washer (10), and bolt (11). Secure wire harness to clip using strap (1) .
Mount clip (3) onto the support located on the backside of the boom foot with bolt (14). Secure the wire harness to clip (3), and strap (1) .
Secure wire harness in place as needed using straps (1), straps (2), or straps (5) .