CAP GP-TRACK IDLER 1079109 - Caterpillar

Introduction
SR4 Generator (Partial View)
(1) VR3 regulator. (2) Terminal box. (3) Droop rheostat location.This manual covers the VR3 voltage regulator as it is used on 10/12 lead, self-excited SR4 generators. This manual must be used in conjunction with service manual Electric Set Generators SENR7958 and Operation and Maintenance Manual SEBU6150. Follow all safety procedures and warnings in the above generator manuals.VR3 regulator (1) is located in generator terminal box (2). There are two VR3 regulators; an earlier one fuse version, and the current two fuse version. The additional fuse of current VR3's, is located next to the single fuse of the earlier version. The additional fuse on current VR3's offers more protection to the internal parts of the VR3.Operation
VR3 Regulator - Current Two Fuse Version Shown
(4) Terminal strip (for attachments). (5) Rheostat (voltage level). (6) Rheostat (voltage gain). (7) Fuses. (8) Fuse cover. (9) Terminal strip (for sensing and power).The purpose of the VR3 regulator is to keep generator output voltage at a rated value. There are two controls on the VR3 that are standard.* Voltage level rheostat (5) provides a no load voltage adjustment of approximately +10 to -20%.* Voltage gain rheostat (6) provides an adjustment to compensate for engine RPM droop with load. Rheostat (6) can be adjusted to keep the same voltage at no load and full load, even when there is a small change in frequency (rpm).Rheostats (5) and (6) are multiple turn. They do not have a fixed stop at the end of travel, but have an override ratchet.
SR4 Generator Schematic (Self-excited 10/12 lead)
(1) VR3 regulator. (10) Lines (3-phase output voltage). (11) Lines (sensing voltage and AC power). (12) Main stator. (13) Main rotor. (14) Exciter stator. (15) Exciter rotor. (16) Lines (VDC excitation voltage).VR3 regulator (1) uses all three phases to sense generator output voltage. Lines (11) function as sensing lines by tapping into generator output and connecting to terminals 20, 22 and 24 (AC input) on fuses (7) and terminal strip (9). [Regulator (1) can be reconnected for single phase sensing]. Like other SR4 generator regulators, the VR3 regulates voltage based on volts per hertz. The VR3 offers an approximate 8 volts per hertz characteristic.Lines (11) also function to provide AC power for excitation to the VR3 regulator. The regulator rectifies the AC voltage and controls the excitation current to exciter stator (14). There are two VR3 regulators; an earlier one fuse version, and the current two fuse version. The additional fuse on, current VR3's, is located next to the single fuse of the earlier version. The additional fuse on current VR3's offers more protection to the internal parts of the VR3.Fuses (7) limit the field current in the case of an internal short circuit or loss of sensing signal. VR3 regulators include an overcurrent shutoff to protect generator components. If the unit operates for an extended period of time at low rpm, the overcurrent shutoff may trip. It will reset automatically when the generator is completely shutoff. For 60 Hz