CAP AS 1518210 - Caterpillar

Illustration 1 g00932447
Install wheel lean pin (1).
Illustration 2 g00932413
Disconnect hose assemblies (2) from wheel lean cylinder (3) .
Attach a suitable lifting device to wheel lean cylinder (3). The weight of wheel lean cylinder (3) is approximately 27 kg (60 lb).
Remove two bolts (5) and retention plate (6) .
Remove pin (7). Use the hoist in order to raise the head end of wheel lean cylinder (3) upward.
Remove bolt (4) and retainer (8) from the pin in the lean arm.
Move wheel lean cylinder (3) toward the rear of the machine. Remove wheel lean cylinder (3) .Disassembly and Assembly Information
Table 1
Required Tools    
Tool     Part Number     Part Description     Qty    
A     127-4904     Repair Stand     1    
B     195-4609     Seal Pick     1    
C     7M-7456     Bearing Mount Compound     1    
D     1P-0808     Multipurpose Grease     1    
E     9U-7868     Spanner Wrench     1    
127-8064 Adjustable Plate     1    
F     1P-0510     Driver Gp     1    
G     1P-1832     Bearing Puller Adapter     1    
4C-9633 Puller Stud     1    
6V-3160 Double Acting Cylinder     1    
1A-1935 Full Nut     1    
9S-5565 Pin Puller Sleeve As     1    
3S-6224 Electric Hydraulic Pump Gp     1    
Illustration 3 g00932574
(A) Dimension from the face to the bearing ... 7.7 0.5 mm (0.30 0.02 inch) (B) Dimension from the face to the bearing ... 7.4 0.5 mm (0.29 0.02 inch) (1) Use a 46 mm socket in order to remove the bolt. (2) Lubricate sealing lips with a thin covering of the lubricant that is being sealed. (3) Apply Tooling (C) to the seal groove prior to assembling the wiper seal. (4) Torque for head ... 600 130 N m (440 95 lb ft)Note: Lubricate the threads with Tooling (D) .Installation Procedure
Note: Cleanliness is an important factor. Before assembly, all parts should be thoroughly cleaned in cleaning fluid. Allow the parts to air dry. Wiping cloths or rags should not be used to dry parts. Lint may be deposited on the parts which may cause later trouble. Inspect all parts. If any parts are worn or damaged, use new parts for replacement.
Illustration 4 g00932412
Attach a suitable lifting device to wheel lean cylinder (3). The weight of wheel lean cylinder (3) is approximately 27 kg (60 lb).
Position the rod end (8A) of wheel lean cylinder (3) on the pin of the wheel lean arm. Move wheel lean cylinder (3) toward the front of the machine.
Lower the head end of wheel lean cylinder (3) downward. Install pin (7) .
Install retention plate (6) and two bolts (5) .
Install retainer (8) and bolt (4) .Note: The dimension between the rod end (8A) of wheel lean cylinder (3) and retainer (8) must be 0.76 mm (0.030 inch).
Connect hose assemblies (2) to wheel lean cylinder (3) .
Illustration 5 g00932447
Remove wheel lean pin (1).
Check