CAP 2245132 - Caterpillar

Installation Procedure
Table 1
Required Tools    
Tool    Part Number    Part Description    Qty    
A     FT-1114     Vacuum Cap     1    
5P-0306 Vacuum Transducer     1    
6V-4142 Fitting     1    
5K-5068 Fitting     1    Note: Cleanliness is an important factor. Before assembly, all parts should be thoroughly cleaned in cleaning fluid. Allow the parts to air dry. Wiping cloths or rags should not be used to dry parts. Lint may be deposited on the parts which may cause later trouble. Inspect all parts. If any parts are worn or damaged, use new parts for replacement.
Illustration 1 g01177313
Connect clutch assembly (7), bracket assembly (6), and axle oil cooler pump (5) with bolts (11) .
Illustration 2 g01177312
Install clutch drive (10) and bolt (9) to clutch assembly (7) .
Illustration 3 g01177311
Position clutch assembly (7), bracket assembly (6), and axle oil cooler pump (5), as shown.
Install bolts (8) .
Illustration 4 g01177310
Connect harness assembly (2), tube assemblies (3), and tube assemblies (4) .
Install belt (1). Refer to Operation and Maintenance Manual, "Belts - Inspect / Adjust / Replace".
Illustration 5 g01165944
Remove Tooling (A) from the hydraulic tank.
Turn the battery disconnect switch to the ON position.