CAP AS-VENTED 2293469 - Caterpillar

Connection Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A 8S-7640 Stand 1
8S-7611 Tube 1
8S-8048 Saddle 1
8S-7615 Pin 1
B 138-7575 Link Bracket 1
C 138-7575 Link Bracket 4
D 1P-0808 Multipurpose Grease 1
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Note: Check the O-ring seals for wear or for damage. Replace the components, if necessary.
Illustration 1 g01439120
Apply Tooling (D) to O-ring seals (8) in order to hold O-ring seals (8) in place during assembly. Install O-ring seals (8) into transmission (2).
Illustration 2 g01439098
Attach Tooling (C) and a suitable lifting device to transmission (2) in order to install transmission (2) onto output transfer gears (3). Install bolts (7). The weight of transmission (2) is 1225 kg (2700 lb). The weight of output transfer gears (3) is 1080 kg (2375 lb). Position Tooling (A) under transmission (2) for support after the removal of Tooling (C) and the suitable lifting device.
Illustration 3 g01439004
Apply Tooling (D) to O-ring seals (6) in order to hold O-ring seals (6) in place during assembly. Install O-ring seals (6) into input transfer gears (1).
Illustration 4 g01438987
Attach Tooling (B) and a suitable lifting device to input transfer gears (1) in order to install input transfer gears (1) onto transmission (2). Install bolts (5). The weight of the input transfer gears (1) is approximately 359 kg (790 lb).
Illustration 5 g01438954
Install yoke assembly (4) onto input transfer gears (1). End By:
Install the transmission, the input transfer gears and the output transfer gears. Refer to Disassembly and Assembly, "Transmission, Input Transfer Gears and Output Transfer Gears - Install".