CAP 2346580 - Caterpillar

Illustration 1 g03732606
Typical example
Table 1
Item Qty Part Specification Description
1 - - Before assembly, the surfaces must be clean and free of protective coating.
2 2 O-Ring Seal Lubricate the bore lightly with the lubricant that is being sealed.
3 - Track Roller Bearing Bore after assembly is 60.130 0.076 mm (2.3673 0.0030 inch). (1)
Bore after assembly is 63.365 0.076 mm (2.4947 0.0030 inch). (2)
4 1 9W-2146 Plug Before assembly, apply blue Loctite 243 to the threads.
Torque to 28 5 N m (248 44 lb in).
5 2 Duo-Cone Seal Gp The rubber toric seals and all the contacting surfaces must be clean and dry at assembly. Before assembly, apply a thin film of 6V-4876 Lubricant to the contacting surfaces of the metal seal rings. The seal rings must be assembled square. The rubber toric seal should not bulge and the rubber toric seal should not twist.
- - - End play for the track roller shaft:
Minimum is 0.25 mm (0.010 inch).
Maximum is 1.25 mm (0.049 inch).
(1) For 461-7752 and 481-4789.
(2) For 508-9458.