CAP-BEARING 2414595 - Caterpillar

Illustration 2 g02970698
Position suitable cribbing in the front and the rear of the track roller frame, as shown.
Drain the propulsion module. Refer to Operation and Maintenance Manual, "Power Train Oil - Change" for the correct draining procedure.
Illustration 3 g02626428
Remove cable strap (1) . Disconnect ground strap (2) .
Illustration 4 g02626431
Illustration 5 g02626434
Disconnect hose assemblies (3) , (5) , and (6) . Remove steering motor (4) and repostion steering motor (4) .
Illustration 6 g02626438
Disconnect harness assemblies (7) and reposition harness assemblies (7) .
Illustration 7 g02626440
Remove clips (8) and reposition hose assemblies (9) .
Illustration 8 g02626462
Remove cover (10) . Repeat for opposite side.
Illustration 9 g02626464
Note: The axle will not come out all the way, but will fully disengage form the propulsion module.
Install Tooling (B) in order to disengage axle splines (11) . Repeat for opposite side.
Illustration 10 g02626476
Remove trunnion cap bolts (12) . Repeat for opposite side.
Illustration 11 g03351742
Install Tooling (C) to remove trunnion cap.
Illustration 12 g02626489
Remove rear propulsion module mount support bolts (13) .
Illustration 13 g02626482
Remove clamp (14) .
Illustration 14 g02626492
Illustration 15 g02626483
Remove sensor (15) . Attach Tooling (A) and a suitable lifting device to propulsion module (16) . The weight of propulsion module (16) is approximately 1270 kg (2800 lb). Remove propulsion module (16) .
Illustration 16 g02626484
Note: Do not pry on the outer edge of mount the casting will break. Pry in the middle of the mount.
Remove adapter (17) and the O-ring seals.