CAP AS-AIR CLEANER 2464611 - Caterpillar

Illustration 11 g01843233
Press the "OK" key. The first "Valve Calibration" dialog reappears.You can now perform the valve calibration for the tilt valve.
Illustration 12 g01318920
At the "Valve Calibration - Select Valve" dialog, press the arrow keys in order to select "Tilt". Press the "OK" key.A screen that is similar to Illustration 12 appears.
Illustration 13 g01843253
Unbolt the angle sensor. Rotate the angle sensor counterclockwise 90 degrees. Install the angle sensor. This allows the angle sensor to measure the tilt of the blade. Press the "OK" key. A screen that is similar to Illustration 14 appears.
Illustration 14 g01843573
Follow the instructions that are listed below.
Park the machine on a level surface that has a clear view of the sky.
Set the blade level and set the blade square to the machine.
Raise the blade sufficiently in order to allow for the full range of tilt.
Ensure that the blade slope increases as the blade is tilted down to the left (counterclockwise).Note: If the reading does not increase, ensure that the angle sensor has been rotated correctly. Check the installation of the angle sensor.
Press the "OK" key.A screen that is similar to Illustration 15 appears.
Illustration 15 g01843596
With the blade tilted as far as possible down to the left, lower the blade until the left tip is just above the ground. Press the "OK" key.A screen that is similar to Illustration 16 appears.
Illustration 16 g01843695
Tilt the blade (clockwise) to the right most extent of its tilt limit. Press the "OK" key.A screen that is similar to Illustration 17 appears.
Once the system is placed in automatic mode, blade movement may occur.Ensure that all personnel are clear of the blade before you place the system in automatic mode.Personal injury or death from crushing could occur.
Illustration 17 g01843136
A message appears warning you that the valve calibration will cause the blade to start moving. Press "OK" in order to continue the calibration. Press the "ESC" key in order to cancel the calibration.A screen that is similar to Illustration 18 appears.A message appears telling you to make sure the auto/manual remote switch is set to "Auto".
Illustration 18 g01843145
Ensure that the auto/manual switch is in the auto position. Press the "OK" key. The calibration of the lift valve will start.A screen that is similar to Illustration 10 appears.
Illustration 19 g01843913
Press the "ESC" key in order to cancel the calibration or press the manual button in order to stop the calibration procedure.A progress bar that shows the progress of the calibration appears. The calibration of the lift valve will take ten to twenty minutes in order to complete. The blade automatically moves up and down during the process.When the valve calibration is complete, a dialog appears. The dialog informs you that the calibration of the lift valve was successful.
Illustration 20 g01843233
Press the "OK" key. When the calibration of the tilt valve is complete, a dialog that is shown in Illustration 21 appears.
Illustration 21 g01319563
This dialog prompts you to return the angle sensor back to the original position so that the angle sensor can be used to compute the pitch of the blade. Press the "OK"