CAP ASSEM. 3T5953 - Caterpillar

Illustration 18 g03739388
Install hose assembly (6) to valve group (2) and connector assembly (7).
Install hose assembly (4) to tube assembly (3).
Install hose assembly (5) to connector assembly (7).
Install tube assembly to existing elbow (A).Mirror Installation for Non-Winch Ready Machines
Required Parts
Table 8
281-3997 Rear View Mirror Gp
Item Qty Part Number Description
1 1 3E-8020 Screw
2 1 281-3998 Mirror As Procedure
Illustration 19 g03740220
As required, install mirror (2) in the location that is shown with screw (1).Note: Add 4C-4030 Thread Lock Compound, or the equivalent to screw (1).
Install the battery and the cab floorplate. Refer to Disassembly and Assembly, KENR6043-00, "Battery-Remove and Install" for the proper procedure for battery installation.
Fill the hydraulic tank to the proper capacity.Electronic Control Module (ECM) Flash Program
Perform the following procedure to flash program the ECM. The ECM is flashed to upgrade the software. Flash programming of the ECM must also be done if the ECM has been replaced. The Caterpillar Electronic Technician (ET) contains the program WinFlash. WinFlash is used to load software into the ECM. The following procedure is used to flash software into the ECM.
Procedure
Connect the data link cable between the communication adapter and the electronic technician.
Connect the data link cable between the communication adapter and the diagnostic connector of the machine.
Turn the disconnect switch and the key start switch to the ON position.
Set the implement lockout to the LOCKED position.
Ensure that the transmission direction switch is in the neutral position.
Ensure that the engine is not running.
Use WinFlash to load the software.Note: WinFlash may appear different due to later versions of the software.
Illustration 20 g01631335
WinFlash is equipped with a "Quick Help to use WinFlash" help screen that can be used for assistance to flash the software. The following steps can also be used to flash the software.
Illustration 21 g01526689
Select the "Blank" ECM.
Click the "Select ECM" button to choose the correct ECM that needs flashed.
Select the "Browse" button to search for the file that contains the 367-0566 Machine Software Gp or the latest flash file.
Illustration 22 g01526711
From the "Flash File Selection" screen, select "3670566V00.fls" that is seen in Illustration 22, and click the "Open" button. The next window will show that the software is being flashed.Note: The auxiliary hydraulic ECM only communicates on the CAN J1939 data link. If the electronic technician does not find the ECM in "WinFlash", confirm that J1939 communication has not been disabled on your laptop computer.Configure Caterpillar Electronic Technician (ET) to 4 bank valve.
Illustration 23 g01526733
From the "Configuration" screen, select "Machine Control".
Illustration 24 g01526737
From the "Description" field, select "Rear Attachment Installation Status.".
From the "Change Parameter Value" screen, select one of the following:
If your machine is not winch ready, select "Single Axis Ripper".
If your machine is winch ready with a winch that had been installed, select "Winch with 4th Function".If, your machine is winch ready and if your machine does not have a winch select one of the following:
Selecting "Winch Pump with 4th Function" will allow you to control the winch pump with the lever and the fourth function with the switch.
Selecting "Single Axis Ripper with